20-101-1207 Rabbit Semiconductor, 20-101-1207 Datasheet - Page 18

• Manufacturer Part Number: 20-101-1207
• Description: RCM4510W FCC CERTIFIED
• Manufacturer: Rabbit Semiconductor
• Type: Transceiver, 802.15.4/ZigBeer

Specifications of 20-101-1207

• Frequency: 2.4GHz
• Wireless Frequency: 29.49 MHz
• For Use With/related Products: RCM4510W
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1144

2.2.3 Step 3 — Connect Programming Cable
The programming cable connects the module to the PC running Dynamic C to download
programs and to monitor the module during debugging.
Connect the 10-pin connector of the programming cable labeled
to header J2 on
PROG
the RCM4510W as shown in Figure 5. Be sure to orient the marked (usually red) edge of
the cable towards pin 1 of the connector. (Do not use the
connector, which is used
DIAG
for a standard serial connection.)
Figure 5. Connect Programming Cable and Power Supply
NOTE: Never disconnect the programming cable by pulling on the ribbon cable.
Carefully pull on the connector to remove it from the header.
Connect the other end of the programming cable to an available USB port on your PC or
workstation.
Your PC should recognize the new USB hardware, and the LEDs in the shrink-wrapped
area of the USB programming cable will flash — if you get an error message, you will
have to install USB drivers. Drivers for Windows XP are available in the Dynamic C
folder — double-click
Drivers\Rabbit USB Programming Cable\WinXP_2K
to install the USB drivers. Drivers for other operating systems are available
DPInst.exe
online at www.ftdichip.com/Drivers/VCP.htm.
12
RabbitCore RCM4500W