DLP-RFID-LP8C DLP Design Inc, DLP-RFID-LP8C Datasheet
DLP-RFID-LP8C
Specifications of DLP-RFID-LP8C
Available stocks
Related parts for DLP-RFID-LP8C
DLP-RFID-LP8C Summary of contents
Page 1
... Sports Event Timing 1.0 INTRODUCTION The DLP-RFID-LP8C is a low-cost, USB-powered module for reading from and writing to ISO 15693, ISO 18000-3, ISO14443* and Tag-it™ intelligent RFID transponder tags via up to eight external antennas. It has the ability to both read and write up to 256 bytes of data in addition to reading the unique identifier (UID/SID). All of the DLP-RFID-LP8C’ ...
Page 2
... APPLICATION DEVELOPMENT Demonstration source code written in Visual C++ is provided with the purchase of a DLP-RFID-LP8C module that demonstrates the communications protocol. Using the Virtual COM Port USB drivers, the DLP-RFID-LP8C appears to the host PC (Windows, Linux, Mac RS232 port. 3.0 MECHANICAL DIMENSIONS IN INCHES (MM) 3 ...
Page 3
... The DLP-FANT requires a coax cable with a reverse-polarity SMA connector at one end for connection to the DLP-RFID-LP8C reader. This coax cable is available in a 3-foot length from DLP Design under part number DLP-COAX1. The DLP-RFID-ANT ships with an attached 15-foot coax cable with a reverse-polarity SMA connector and provides inches of read range ...
Page 4
... FCC/IC REQUIREMENTS FOR MODULAR APPROVAL Any changes or modifications to the DLP-RFID-LP8C’s printed circuit board could void the user’s authority to operate the equipment. Operation of an unapproved antenna could void the user’s authority to operate the equipment. 4.4 WARNINGS Operation is subject to the following two conditions: (1) This device may not cause harmful interference; ...
Page 5
... ADDITIONAL INFORMATION FOR OEM INTEGRATORS The end user should NOT be provided with any instructions on how to remove or install the DLP-RFID- LP8C. This device has been pre-certified to operate with the antenna models listed below: DLP Design Large Loop Antenna DLP Design Small Loop Antenna DLP Design Ferrite Antenna 5 ...