DLP-RFID1-RG DLP Design Inc, DLP-RFID1-RG Datasheet
DLP-RFID1-RG
Specifications of DLP-RFID1-RG
Related parts for DLP-RFID1-RG
DLP-RFID1-RG Summary of contents
Page 1
... INTRODUCTION The DLP-RFID1 is a low-cost, USB-powered module for reading from and writing to ISO 15693, ISO 18000-3, and Tag-it™ intelligent RFID transponder tags. It has the ability to both read and write up to 256 bytes of data in addition to reading the unique identifier (UID/SID). All of the DLP-RFID1’s electronics and antenna reside within the compact unit, and all operational power is taken from the host PC via the USB interface ...
Page 2
... An RFID tag consists of an integrated circuit attached to an antenna. In the case of the tags used with the DLP-RFID1, the antenna is in the form of conductive ink “printed” material that allows for connection to the integrated circuit. This type of passive (battery-free) tag is commonly referred “ ...
Page 3
... DLP-RFID1 reader. 6.0 SUPPORTED TAG LIBRARY FUNCTIONS The free version of the software library for the DLP-RFID1 only supports the reading of a single tag’s serial number, access to the reader’s permanent serial number, and control of the integrated pass/fail beeper. The Professional Developer’s Library supports these additional functions: Texas Instruments Tag-It™ ...
Page 4
... SUPPORTED TRANSPONDER TAGS The DLP-RFID1 was designed to support transponder tags manufactured by Texas Instruments. The following Texas Instruments tags have been tested and approved for use with the DLP-RFID1: Laundry Tags: Pro: RX-HDT-DVBS-N0 Plus: RF-HDT-DVBB 24mm Circular: Pro: RI-I16-114A-S1 ...
Page 5
... AGENCY IDENTIFICATION NUMBERS Compliance with the appropriate regulatory agencies is essential in the deployment of all transceiver devices. DLP Design has obtained modular approval for this RF product such that an OEM need only meet a few basic requirements in order to utilize their end product under this approval. Corresponding ...
Page 6
... C37. This output is designed to drive a 13.56MHz, 50-Ohm antenna. The use of any other type of antenna may cause permanent damage to the DLP-RFID1. 9.3 FCC/IC REQUIREMENTS FOR MODULAR APPROVAL Any changes or modifications to the DLP-RFID1’s printed circuit board could void the user’s authority to operate the equipment. 9.4 WARNINGS ...
Page 7
... This product and its documentation are supplied on an as-is basis, and no warranty as to their suitability for any particular purpose is either made or implied. DLP Design will not accept any claim for damages whatsoever arising as a result of use or failure of this product. Your statutory rights are not affected. ...