A22L-HY-T1-01A Omron, A22L-HY-T1-01A Datasheet - Page 27

• Manufacturer Part Number: A22L-HY-T1-01A
• Description: SWITCH PB ILLUM RND ALT SPST YEL
• Manufacturer: Omron
• Series: A22r
• Type: Illuminatedr

Specifications of A22L-HY-T1-01A

• Circuit: SPST-NC
• Switch Function: On-Off
• Contact Rating @ Voltage: 10A @ 110VAC
• Actuator Type: Round, Half Guard
• Illumination Type, Color: LED, Yellow
• Illumination Voltage (nominal): 110 VAC
• Mounting Type: Panel Mount
• Termination Style: Screw Terminal
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: A22LHYT101A

Securing the Connector Cable
1. Insert the connector into the cable port hole in the Box and secure
2. Open a hole in the thin rubber section of the rubber ring.
3. Pass the tightening cap through the cable, insert the cable into the
Installing the Switch Blocks
Fixing nut
Hook the small protrusion on the Switch Block into the groove on
the Mounting Latch on the other side of the lever, then push up the
Switch Block in the direction indicated by the arrow in the figure
below.
with the fixing nut inside the box.
connector, and tighten the hexagonal nut to secure the cable.
Inside
Cable diameter
9 to 11 dia.
Box
7 to 9 dia.
Mounting
Latch
http://www.ia.omron.com/
Rubber washer
Outside
Connector
Tightening cap
Switch Block
A22Z-3500-1
A22Z-3500-2
Connector
Protrusion
Lever
Cable
Removing the Switch Blocks
Wiring
Wiring Round Crimp Terminals
Engraving
Insert a screwdriver between the Mounting Latch and the Switch
Block, then push down the screwdriver in the direction indicated by
the arrow in the following figure.
Loosen the terminal screw from the Switch Unit until it completely
comes off the groove, insert a screwdriver as shown in the following
figure, then push up the washer in the direction indicated by the
arrow to temporarily secure it. Now, a round crimp terminal can be
connected. After inserting the terminal, tighten the screws to
complete wiring.
Engrave the characters on the surface on the
Cap. Make sure that the characters are
aligned parallel to the imaginary line
connecting the two protruding portions to the
left and right of the Cap.
The characters must not be engraved deeper
than 0.5 mm. Apply an alcohol-based paint
coating, such as melamine, alkyd, or acrylic
resin paint coating, to the engraved
characters.
(c)Copyright OMRON Corporation 2007 All Rights Reserved.
Washer
Screw
Use either of the following screwdrivers.
Flat-head
screwdriver
Phillips
screwdriver
3 to 6 mm
3 to 6 mm
Screwdriver
Screwdriver
Protruding portions
on Cap
A22
27