VNCLO-MB1A FTDI, VNCLO-MB1A Datasheet - Page 18

• Manufacturer Part Number: VNCLO-MB1A
• Description: Interface Modules & Development Tools Vinculo Motherboard Req VNC2DEBUGMODULE
• Manufacturer: FTDI

Specifications of VNCLO-MB1A

• Interface Type: USB, Serial, UART, FIFO, SPI
• Data Bus Width: Serial, 8 bit
• Operating Supply Voltage: 9 V to 12 V
• Product: Interface Development Tools
• Features: Precompiled Drivers For A Variety Of Interfaces
• Kit Contents: Board
• Kit Features: Precompiled Drivers, Compatible With Existing Shields
• Mcu Supported Families: VNC2
• Silicon Family Name: Vinculum
• For Use With/related Products: VNC2
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: VINCULO

Document Reference No.: FT_000327
Vinco Development Module Datasheet Version 2.0
Clearance No.: FTDI#173
7
Firmware
7.1 Firmware Support
The Vinco module is pre-loaded with the Vinco Manufacturing Test firmware which configures the VNC2-
64Q USB port 1 to slave mode and enumerates the chip as an FT232BM device. The firmware also
configures VNC2-64Q ‘s GPIO Port A as LEDs (LED1, LED2 and LED3) outputs and allows the user to send
and receive data in a loopback mode. The LED1 blinks when data has been received and sent back and
the LED2 blinks when there is no data read from the USB port 1 (FT232BM device). The LED3 is ON when
the Vinco module is powered. The firmware C source code (Vinco Manufacturing Test Program/Firmware)
is available as a free download from the
FTDI
website. However the VNC2-64Q on the Vinco can be
programmed with the customers own firmware created using the Vinculum II firmware development tool-
chain or with various pre-compiled firmware profiles to allow a designer to easily change the functionality
of the chip. Please refer to: -
FTDI website
for full details on available pre-compiled firmware.
7.2 Available Firmware
Please refer to: -
FTDI website
for full details.
7.3 Firmware Upgrades
Refer to the debugger interface section 6 which can be used to update the firmware.
7.4 Arduino Shield Compatible Firmware
As the mechanical form factor and pin out is inspired by the Arduino Duemilanove module, many Arduino
shields are compatible with the Vinco module. Libraries and example applications will be made available
allowing the Vinco to be used in association with stepper motors, GSM modules, LCD displays and many
other applications. Additionally with the IDE it will be possible for users to develop new shields and
applications.
Copyright © 2010-2011 Future Technology Devices International Limited
14