FT245RQ-REEL FTDI, FT245RQ-REEL Datasheet - Page 9

• Manufacturer Part Number: FT245RQ-REEL
• Description: USB Interface IC USB to Parallel FIFO Enhanced IC QFN-32
• Manufacturer: FTDI

Specifications of FT245RQ-REEL

• Mounting Style: SMD/SMT
• Package / Case: QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Pin No.
11
12
13
14
22
23
Table 3.4 FIFO Interface Group (see note 3)
Notes:
1. The minimum operating voltage VCC must be +4.0V (could use VBUS=+5V) when using the
2. For details on how to use an external crystal, ceramic resonator, or oscillator with the FT245R,
3. When used in Input Mode, the input pins are pulled to VCCIO via internal 200kΩ resistors. These
internal clock generator. Operation at +3.3V is possible using an external crystal oscillator.
please refer Section 8.2
pins can be programmed to gently pull low during USB suspend (PWREN# = “1”) by setting an
option in the internal EEPROM.
Name
D3
PWREN#
RD#
WR
TXE#
RXF
Copyright © 2010 Future Technology Devices International Limited
Type
I/O
Output
Input
Input
Output
Output
Description
FIFO Data Bus Bit 3
Goes low after the device is configured by USB, then high during USB suspend.
Can be used to control power to external logic P-Channel logic level MOSFET
switch. Enable the interface pull-down option when using the PWREN# pin in this
way. Should be pulled to VCCIO with 10kΩ resistor.
Enables the current FIFO data byte on D0...D7 when low. Fetched the next FIFO
data byte (if available) from the receive FIFO buffer when RD# goes from high to
low. See Section 3.5 for timing diagram.
Writes the data byte on the D0...D7 pins into the transmit FIFO buffer when WR
goes from high to low. See Section 3.6 for timing diagram.
When high, do not write data into the FIFO. When low, data can be written into
the FIFO by strobing WR high, then low. During reset this signal pin is tri-state.
See Section 3.6 for timing diagram.
When high, do not read data from the FIFO. When low, there is data available in
the FIFO which can be read by strobing RD# low, then high again. During reset
this signal pin is tri-state. See Section 3.5 for timing diagram.
If the Remote Wakeup option is enabled in the internal EEPROM, during USB
suspend mode (PWREN# = 1) RXF# becomes an input. This can be used to wake
up the USB host from suspend mode by strobing this pin low for a minimum of
20ms which will cause the device to request a resume on the USB bus.
FT245R USB FIFO IC Datasheet Version 2.10
Document No.: FT_000052
Clearance No.: FTDI# 39
9