LM5009AEVAL/NOPB National Semiconductor, LM5009AEVAL/NOPB Datasheet - Page 8

• Manufacturer Part Number: LM5009AEVAL/NOPB
• Description: EVAL BOARD FOR LM5009A
• Manufacturer: National Semiconductor

Specifications of LM5009AEVAL/NOPB

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

www.national.com
Regulation Comparator
The feedback voltage at FB is compared to an internal 2.5V
reference. In normal operation (the output voltage is regulat-
ed), an on-time period is initiated when the voltage at FB falls
below 2.5V. The buck switch will stay on for the on-time,
causing the FB voltage to rise above 2.5V. After the on-time
period, the buck switch will stay off until the FB voltage again
falls below 2.5V. During start-up, the FB voltage will be below
2.5V at the end of each on-time, resulting in the minimum off-
time of 300 ns. Bias current at the FB pin is nominally 100 nA.
Over-Voltage Comparator
The feedback voltage at FB is compared to an internal 2.875V
reference. If the voltage at FB rises above 2.875V the on-time
pulse is immediately terminated. This condition can occur if
the input voltage, or the output load, change suddenly. The
buck switch will not turn on again until the voltage at FB falls
below 2.5V.
FIGURE 2. Startup Sequence
8
On-Time Generator and Shutdown
The on-time for the LM5009A is determined by the R
and is inversely proportional to the input voltage (Vin), result-
ing in a nearly constant frequency as Vin is varied over its
range. The on-time equation for the LM5009A is:
R
V
This requirement limits the maximum frequency for each ap-
plication, depending on V
The LM5009A can be remotely disabled by taking the R
pin to ground. See
between 1.5 and 3.0 volts, depending on Vin and the value of
the R
IN
T
) greater than 400 ns, for proper current limit operation.
should be selected for a minimum on-time (at maximum
T
resistor.
T
ON
= 1.385 x 10
Figure
IN
3. The voltage at the R
and V
-10
x R
OUT
T
.
/ V
IN
30087114
T
/SD pin is
T
resistor,
T
/SD
(2)