LM3915N-1 National Semiconductor, LM3915N-1 Datasheet - Page 11

• Manufacturer Part Number: LM3915N-1
• Description: IC, DOT/BAR DISPLAY DRIVER, DIP-18
• Manufacturer: National Semiconductor

Specifications of LM3915N-1

• Led Driver Application: VU Meter, Power Meters
• No. Of Outputs: 10
• Output Current: 30mA
• Input Voltage: 3V To 25V
• Dimming Control Type: Analog
• Operating Temperature Range: 0°C To +70°C
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Application Hints
D1, D2: 1N914 or 1N4148
D1, D2, D3, D4: 1N914 or 1N4148
CASCADING THE LM3915
To display signals of 60 dB or 90 dB dynamic range, multiple
LM3915s can be easily cascaded. Alternatively, it is possible
to cascade an LM3915 with LM3914s for a log/linear display
or with an LM3916 to get an extended range VU meter.
A simple, low cost approach to cascading two LM3915s is to
set the reference voltages of the two chips 30 dB apart as in
Figure 5. Potentiometer R1 is used to adjust the full scale
voltage of LM3915 #1 to 316 mV nominally while the second
IC’s reference is set at 10V by R4. The drawback of this
method is that the threshold of LED #1 is only 14 mV and,
(Continued)
FIGURE 3. Precision Full-Wave Average Detector
FIGURE 4. Precision Full-Wave Peak Detector
11
since the LM3915 can have an offset voltage as high as
10 mV, large errors can occur. This technique is not recom-
mended for 60 dB displays requiring good accuracy at the
first few display thresholds.
A better approach shown in Figure 6 is to keep the reference
at 10V for both LM3915s and amplify the input signal to the
lower LM3915 by 30 dB. Since two 1% resistors can set the
amplifier gain within
However, an op amp offset voltage of 5 mV will shift the first
LED threshold as much as 4 dB, so that an offset trim may
be required. Note that a single adjustment can null out offset
±
00510411
0.2 dB, a gain trim is unnecessary.
00510412
www.national.com