LM2594M-5.0 National Semiconductor, LM2594M-5.0 Datasheet - Page 5

• Manufacturer Part Number: LM2594M-5.0
• Description: IC, STEP-DOWN REGULATOR, 8-SOIC
• Manufacturer: National Semiconductor

Specifications of LM2594M-5.0

• Primary Input Voltage: 12V
• No. Of Outputs: 1
• Output Voltage: 5V
• Output Current: 500mA
• No. Of Pins: 8
• Operating Temperature Range: -40°C To +125°C
• Supply Voltage Range: 4.5V To 40V
• Termination Type: SMD
• Dc To Dc Converter Type: Inverting/Step Down
• Number Of Outputs: 1
• Pin Count: 8
• Input Voltage: 40V
• Switching Freq: 173kHz
• Efficiency: 82%
• Package Type: SOIC N
• Output Type: Fixed
• Switching Regulator: Yes
• Mounting: Surface Mount
• Input Voltage (min): 4.5V
• Operating Temp Range: -40C to 125C
• Operating Temperature Classification: Automotive
• Filter Terminals: SMD
• Rohs Compliant: No
• Input Voltage Primary Max: 40V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

All Output Voltage Versions
Electrical Characteristics
Note 2: The human body model is a 100 pF capacitor discharged through a 1.5k resistor into each pin.
Note 3: Typical numbers are at 25˚C and represent the most likely norm.
Note 4: All limits guaranteed at room temperature (standard type face) and at temperature extremes (bold type face). All room temperature limits are 100% produc-
tion tested. All limits at temperature extremes are guaranteed via correlation using standard Statistical Quality Control (SQC) methods. All limits are used to calculate
Average Outgoing Quality Level (AOQL).
Note 5: External components such as the catch diode, inductor, input and output capacitors, and voltage programming resistors can affect switching regulator sys-
tem performance. When the LM2594/LM2594HV is used as shown in the Figure 1 test circuit, system performance will be as shown in system parameters section
of Electrical Characteristics.
Note 6: The switching frequency is reduced when the second stage current limit is activated. The amount of reduction is determined by the severity of current over-
load.
Note 7: No diode, inductor or capacitor connected to output pin.
Note 8: Feedback pin removed from output and connected to 0V to force the output transistor switch ON.
Note 9: Feedback pin removed from output and connected to 12V for the 3.3V, 5V, and the ADJ. version, and 15V for the 12V version, to force the output transistor
switch OFF.
Note 10: V
Note 11: Junction to ambient thermal resistance with approximately 1 square inch of printed circuit board copper surrounding the leads. Additional copper area will
lower thermal resistance further. See application hints in this data sheet and the thermal model in Switchers Made Simple
Typical Performance Characteristics
Normalized
Output Voltage
Switch Saturation
Voltage
IN
= 40V for the LM2594 and 60V for the LM2594HV.
DS012439-7
DS012439-4
(Continued)
Line Regulation
Switch Current Limit
5
DS012439-8
DS012439-5
Efficiency
Dropout Voltage
®
software.
www.national.com
DS012439-6
DS012439-9