SAK-C164CI-8E25M Infineon Technologies, SAK-C164CI-8E25M Datasheet - Page 42

• Manufacturer Part Number: SAK-C164CI-8E25M
• Description: IC, 16BIT MCU, 64K OTP, MQFP80, 164
• Manufacturer: Infineon Technologies

Specifications of SAK-C164CI-8E25M

• Core Size: 16bit
• No. Of I/o's: 59
• Program Memory Size: 64KB
• Ram Memory Size: 4KB
• Cpu Speed: 25MHz
• Oscillator Type: External Only
• No. Of Timers: 5
• Digital Ic Case Style: MQFP
• Supply Voltage: RoHS Compliant
• Controller Family/series: C164CI
• Peripherals: ADC
• Rohs Compliant: Yes

Notes
1)
2)
3)
4)
5)
6)
7)
Semiconductor Group
V
cases will be X000
The limit values for f
This parameter includes the sample time t
result register with the conversion result.
Values for the basic clock t
This parameter depends on the ADC control logic. It is not a real maximum value, but rather a fixum.
TUE is tested at V
defined voltage range.
The specified TUE is guaranteed only if an overload condition (see
not selected analog input pins and the absolute sum of input overload currents on all analog input pins does
not exceed 10 mA.
During the reset calibration sequence the maximum TUE may be 4 LSB.
During the conversion the ADC’s capacitance must be repeatedly charged or discharged. The internal
resistance of the reference voltage source must allow the capacitance to reach its respective voltage level
within each conversion step. The maximum internal resistance results from the programmed conversion
timing.
Not 100% tested, guaranteed by design.
During the sample time the input capacitance C
internal resistance of the analog source must allow the capacitance to reach its final voltage level within t
After the end of the sample time t
Values for the sample time t
AIN
may exceed V
AREF
H
AGND
BC
or X3FF
=5.0V, V
must not be exceeded when selecting the CPU frequency and the ADCTC setting.
or V
BC
S
AREF
H
depend on programming and can be taken from the table above.
depend on programming and can be taken from the table above.
, respectively.
AGND
S
up to the absolute maximum ratings. However, the conversion result in these
, changes of the analog input voltage have no effect on the conversion result.
=0V, V
S
DD
, the time for determining the digital result and the time to load the
=4.9V. It is guaranteed by design for all other voltages within the
I
can be charged/discharged by the external source. The
42
I
OV
specification) occurs on maximum 2
C164CI
1998-02
S
.