MINI-PS-100-240AC/5DC/3 Phoenix Contact, MINI-PS-100-240AC/5DC/3 Datasheet - Page 7

• Manufacturer Part Number: MINI-PS-100-240AC/5DC/3
• Description: POWER SUPPLY PRIMARY SWITCH MODE
• Manufacturer: Phoenix Contact

Specifications of MINI-PS-100-240AC/5DC/3

• Power Supply Type: Switch Mode
• Power Supply Output Type: Fixed
• No. Of Output Channels: 1
• Input Frequency: 65Hz
• Output Voltage: 5VDC
• Output Current: 3A
• Input Voltage: 85V To 265V
• Supply Voltage: RoHS Compliant
• No. Of Outputs: 1
• Supply Voltage Typ: 110V AC /
• Rohs Compliant: Yes

Power Supply, Primary Switch Mode, Narrow Design – MINI-PS-100-240AC/5DC/3
6.4. Output (
"–" screw connections on the screw-cage connection
2 2 2 2
DC on the potentiometer
Protecting the Secondary Side:
proof. In the event of an error, the output voltage is
limited to a maximum of 6 V DC.
correct size for the maximum output current or have
separate fuse protection.
sections to keep voltage drops on the cables to a
minimum.
DC OK LED
evaluation in the control cabinet.
LED on
LED off
7. Function
7.1. Output Characteristic Curve
voltage for a few minutes (P
U/I characteristic curve shown in Figure 10. The output
current is limited to I
reduced until the short circuit on the secondary side is
removed.
capacitive loads and devices with DC/DC converters
can be supplied by MINI POWER in the input circuit
without any problems.
in your system configuration is ensured at all times.
. The output voltage set upon delivery is 5 V DC.
The 5 V DC connection is made using the "+" and
The output voltage can be adjusted from 4.5 to 5.5 V
The device is electronic short-circuit-proof and idling-
It should be ensured that all output cables are the
The secondary side cables should have large cross
The green DC OK LED enables local function
The device can supply up to 6 A at 5 V DC output
With high loads, the working point demonstrates the
The U/I characteristic curve ensures that both heavy
Connected fuses are reliably tripped. The selectivity
a)
b) No AC supply voltage is present or there is a device
Normal operation of the power supply
The output voltage is ≤ 4 V DC.
There is a secondary load short circuit or overload
outside the POWER BOOST area.
fault.
2 2 2 2
, Figure 9)
BOOST
3 3 3 3
. The secondary voltage is
.
out
= 30 W).
PHOENIX CONTACT page 7 of 8
U
U
OUT
[ V ]
N
5
< 60 °C
15 W
I
3
N
I
30 W
BOOST
6
I
Figure 10
OUT
[ A ]