DD-9616BE-2A DENSITRON, DD-9616BE-2A Datasheet - Page 23

• Manufacturer Part Number: DD-9616BE-2A
• Description: PMOLED, 96*16, BLUE
• Manufacturer: DENSITRON

Specifications of DD-9616BE-2A

• Resolution: 96 X 16
• Viewing Area (h X W): 5.504mm X 23.104mm
• Pixel Size (h X W): 0.204mm X 0.204mm
• Voltage Rating: 2.8V
• Interface: Serial
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

9.2 STORAGE
When storing OEL display modules, put them in static electricity preventive bags avoiding exposure
to direct sun light nor to lights of fluorescent lamps, etc. and, also, avoiding high temperature and high
humidity environments or low temperature (less than 0°C) environments. (We recommend you to store
these modules in the packaged state when they were shipped from Factory.)
At that time, be careful not to let water drops adhere to the packages or bags nor let dewing occur with
them.
If electric current is applied when water drops are adhering to the surface of the OEL display module,
when the OEL display module is being dewed or when it is placed under high humidity environments,
the electrodes may be corroded and be careful about the above.
9.3 DESIGNING
The absolute maximum ratings are the ratings which cannot be exceeded for
OEL display module, and if these values are exceeded, panel damage may be happen.
To prevent occurrence of malfunctioning by noise: pay attention to satisfy the VIL and VIH
specifications and, at the same time, to make the signal line cable as short as possible.
We recommend you to install excess current preventive unit (fuses, etc.) to the power circuit (VCI).
(Recommend value: 0.5A)
Pay sufficient attention to avoid occurrence of mutual noise interference with the neighbouring
devices.
As for EMI, take necessary measures on the equipment side basically.
When fastening the OEL display module, fasten the external plastic housingsection.
If power supply to the OEL display module is forcibly shut down by such errors as taking out the main
battery while the OEL display panel is in operation, we cannot guarantee the quality of this OEL
display module.
The electric potential to be connected to the rear face of the IC chip should be as follows: SSD1351
* Connection (contact) to any other potential than the above may lead to rupture of the IC.
9.4 Disposing
Request the qualified companies to handle industrial wastes when disposing of the OEL display
modules. Or, when burning them, be sure to observe the environmental and hygienic laws and
regulations.
9.5 Other
When an OEL display module is operated for a long of time with fixed pattern may remain as an after
image or slight contrast deviation may occur. Nonetheless, if the operation is interrupted and left
unused for a while, normal state can be restored. Also, there will be no problem in the reliability of the
module.
DD-9616BE-2A
REV. A
Product No.
Page
23 / 24
Copyright ©2009 DENSITRON TECHNOLOGIES plc. All rights reserved. – Proprietary Data