TORX147 Toshiba, TORX147 Datasheet - Page 4

• Manufacturer Part Number: TORX147
• Description: RECEIVER, FIBRE OPTIC
• Manufacturer: Toshiba

Specifications of TORX147

• Connector Type: TosLink
• Data Rate Max: 15Mbps
• Data Rate Min: 0.1Mbps
• External Depth: 13.5mm
• External Length / Height: 19.5mm
• External Width: 11.5mm
• High Level Output Current: -2mA
• High Level Output: RoHS Compliant
• Svhc: No SVHC (20-Jun-2011)
• Rohs Compliant: Yes

(6)
(7)
(8)
(9)
(10) Output
(11) Soldering condition
(12) Precautions when disposing of devices and packing materials.
(13) Precautions during use
Panel attachment
TORX147(F,T) has hole for panel attachment. Please be sure to attach it to panel with self- tapping
screw.
Solvent
Protective cap
When the TORX147(F,T) is not in use, attach the protective cap.
Supply voltage
Use the supply voltage within the recommended operating condition (V
that supply voltage does not exceed the maximum rating value of 4.5 V, even for an instant.
If the receiver output is at low and is connected to the power supply, or if the output is high and is
connected to GND, the internal IC may be destroyed.
Solder at 260°C or less for no more than ten seconds.
When disposing devices and packing materials, follow the procedures stipulated by local regulations
in order to protect the environment against contamination.
Toshiba is continually working to improve the quality and the reliability of their products.
Nevertheless, semiconductor devices in general can malfunction or fail due to their inherent electrical
sensitivity and their vulnerability to physical stress. It is the responsibility of the buyer, when
utilizing Toshiba products, to observe standards of safety, and to avoid situations in which the
malfunction or failure of a Toshiba product could cause loss of human life, bodily injury or damage to
property.
When developing equipment, please ensure that Toshiba products are used within the specified
operating ranges set forth in the most recent product specifications. Also, please keep in mind the
precautions and conditions set forth in the Toshiba Semiconductor Reliability Handbook.
When using solvent for flux removal, do not use a high acid or high alkali solvent. Be careful not to
pour solvent in to the optical connector ports. If solvent is inadvertently poured in to them, clean it off
using cotton tips.
4
CC
= 2.7 to 3.6V). Make sure
TORX147(F,T)
2004-10-21