FIREBLADE-S1 RF Solutions, FIREBLADE-S1 Datasheet - Page 4

• Manufacturer Part Number: FIREBLADE-S1
• Description: Basic Stamp Development Kit
• Manufacturer: RF Solutions

Specifications of FIREBLADE-S1

• Kit Contents: 1-channel Receiver/transmitter
• Tool / Board Applications: Wireless Connectivity-ZigBee, RF, Infrared, USB
• Development Tool Type: Hardware - Daughter Card
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

DSFIREFLY-3
Any transmitter button can be learnt to one or many of the receiver output relays.
Each button must be learnt to each relay individually by following this procedure:
1.
2.
3.
4.
5.
NOTE: You cannot erase individual Tx encoders
Receiver Outputs
The jumper links configure the outputs to be Momentary, Latching or Timed.
The jumper links are made / removed by a small link ‘cap’ placed over the pin header.
To learn a new transmitter switch follow this procedure
Erasing Receivers Memory
1. Press and hold the receiver Learn Switch for approx 10 seconds.
2. When the Learn LED turns OFF all memory is erased
3. This is factory default state which is indicated by all output LED’s flashing together.
Jumper Links
Connected
Connected
Connected
March 08
To select the receiver output relay to learn to:
a.
b.
c.
d.
Press the button on the transmitter you want to learn to the relay output.
The Learn LED will then illuminate, press the same transmitter button again.
The Learn LED will then flash to indicate learning is complete.
To test the operation, press the transmitter button again and you will hear the relay ‘click’ as it operates.
(LK2 - 4)
Open
Open
Open
LK0
Briefly press the receiver Learn switch (SW1) once
The Learn LED will flash once to indicate output relay 1 is selected
After the LED stops flashing, press the Learn switch again to select the next relay channel
Repeat step c until the required output relay is selected.
R
ADIO
Mom (The Output operates for as long as the transmitter switch is held on)
Latch (The Output changes state each time the Transmitter is operated)
Connected
Connected
©2008 REG No 277 4001, ENGLAND.
R
Open
Open
LK1
EMOTE
C
ONTROL
Output 1, 0 to 5 minutes using Timer selection Potentiometer.
S
Outputs 2 - 4
Fixed to ½ Second Momentary o/p
YSTEMS
Relay Output 1 Only
Output 1 Latching
Momentary
Page 4
F
IRE
F
IRE
B
F
LADE
LY