FS2003(UN) Equinox Technologies, FS2003(UN) Datasheet - Page 41

• Manufacturer Part Number: FS2003(UN)
• Description: PROGRAMMER, ISP
• Manufacturer: Equinox Technologies

Specifications of FS2003(UN)

• Mcu Supported Families: Atmel AT89S, Atmega, AVR, Attiny, Philips T89C51Rx2, P89C51Rx2, P89C66x
• Programmer Type: ISP
• External Depth: 31mm
• Height: 189mm
• Length: 80mm
• Weight: 0.75kg

3.5 Development Mode (EDS)
3.5.1 Overview
In ‘Development Mode’, the programmer is controlled from the EQTools - Equinox Development Suite
running on a PC. The Development utility is called Equinox Development Suite or EDS for short. In
this mode it is NOT necessary to upload the ‘Programming Project’ to the programmer as the EDS
utility co-ordinates all programming operations.
In EDS Mode, you can perform the following actions under PC control:
3.5.2 Launching EDS (Development Mode)
To test a Target Chip in EDS (Development Mode), follow the instructions detailed below:
30
The EDS Wizard will now launch
•
•
•
•
•
•
•
•
•
Write data directly to a Target Device from the PC e.g. a HEX file
Read data from a Target Device to a file on the PC
Write / Read the Configuration Fuses of a Target Device
Write / Read the Security Fuses of a Target Device
Read the Target Vcc Voltage
Launch EQTools
From the Welcome Screen, select the ‘Create a new Equinox Development Project (EDS)’
option.
OR
From the left-hand pane, select the <Development> tab and then select ‘New Development
Project’.
Follow the EDS Wizard by filling in each tab and then clicking the <Next> button:
•
•
•
•
•
•
•
Select Programmer
Select Device
Select Target Oscillator
Select Target Voltage Current
Select FLASH Data File (optional)
Select EEPROM Data File (optional)
At the end of the EDS Wizard:
Click the <Test> button
FS2003 ISP Programmer - User Guide V1.01 – 4th February 2004