B51-328-3188220 ITT SEALECTRO, B51-328-3188220 Datasheet - Page 45

• Manufacturer Part Number: B51-328-3188220
• Description: RF/COAXIAL, SMB PLUG, R/A, 50OHM, CRIMP
• Manufacturer: ITT SEALECTRO

Specifications of B51-328-3188220

• Body Style: Right Angle Plug
• Coaxial Termination: Crimp
• Rg Cable Type: RG-174, 316
• Contact Material: Beryllium Copper
• Contact Plating: Gold
• Connector Type: SMB Coaxial
• Impedance: 50ohm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Cannon 50 Ohm Connectors
A A I I - - 1 1 2 2 9 9 , , A A I I - - 2 2 8 8 6 6 & & A A I I - - 6 6 9 9 6 6
www.ittcannon.com
Dimensions shown in mm (inch)
Specifications and dimensions subject to change
STEP 1-2
STEP 4
STEP 5
STEP 7
STEP 8
STEP 6
SHRINKABLE
TUBING
HEAT
C
SOLDER
A
B
S S S S M M B B / / S S S S M M C C R R i i g g h h t t A A n n g g l l e e C C o o n n n n e e c c t t o o r r s s , ,
C C r r i i m m p p T T y y p p e e f f o o r r B B r r a a i i d d e e d d C C a a b b l l e e
1.
2.
3.
4.
5.
6.
7.
8.
Only common cable retention features are shown in detail. Various body
configurations can apply.
FERRULE
CRIMP
Slide heat shrinkable tubing and ferrule on to cable.
Trim cable to dimensions shown:
Tin center conductor. (DO NOT OVER TIN).
Slide body over cable dielectric and under the braid until braid is flush
against underside of rear body. Ensure center conductor is located in the
forked end of the contact. NOTE: When using cables with inflexible jackets it
is permissible to make two 3,00 (.118) longitudinal slits in the outer jacket.
Slide ferrule flush against the body and crimp in position using Cannon’s
Crimp Tool and suitable Die Set (see table).
Using a small soldering iron solder center conduct to contact. NOTE: The
center conductor should not protrude beyond the contact or touch the body.
Solder should not protrude beyond the slotted section of the contact.
Press insert into place or locate the cap in rear of body and dimple or lightly
punch to ensure it is locked into position (recommended tool, flat pin ø 3,07
+/- 0,05) (.121 +/- .002).
Slide heat shrinkable tubing over ferrule flush against body and heat until
tubing shrinks down.
Assembly Instruction No.
Cable Numbers
AI-129
AI-286
AI-696
RG196/U
RG316/U
RD316
45
INSERT OR CAP
Cable Code
3196
3188
3875
5,56 (.219)
6,35 (.250)
6,22 (.245)
ASSEMBLY INSTRUCTIONS
A
REAR BODY
2,67 (.105)
3,25 (.128)
3,84 (.151)
Die Size
2,77 (.109)
2,77 (.109)
2,54 (.100)
B
T1025/1
T1025/4
T1025/9
Die Set
1,19 (.047)
0,79 (.031)
1,14 (.045)
C