B51-328-3188220 ITT SEALECTRO, B51-328-3188220 Datasheet - Page 52

• Manufacturer Part Number: B51-328-3188220
• Description: RF/COAXIAL, SMB PLUG, R/A, 50OHM, CRIMP
• Manufacturer: ITT SEALECTRO

Specifications of B51-328-3188220

• Body Style: Right Angle Plug
• Coaxial Termination: Crimp
• Rg Cable Type: RG-174, 316
• Contact Material: Beryllium Copper
• Contact Plating: Gold
• Connector Type: SMB Coaxial
• Impedance: 50ohm
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Cannon 50 Ohm Connectors
B B A A I I - - 0 0 0 0 1 1
STEP 13
STEP 12
STEP 11
STEP 1
STEP 2
STEP 7
STEP 9
STEP 3
STEP 5
CLAMP NUT
S S M M B B / / S S M M C C S S t t r r a a i i g g h h t t C C o o n n n n e e c c t t o o r r s s , , C C l l a a m m p p T T y y p p e e f f o o r r B B r r a a i i d d e e d d C C a a b b l l e e
WASHER
No.1
GASKET
(.138)
(.216)
3,50
5,50
(.098)
2,50
WASHER
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. Place a small solder preform made from 0,26 - 0,31 (.010 - .012) dia (28
11. Push contact on center conductor as far as possible. Heat center
12. Slide on front insulator flush against rear insulator (if not already
13. Move clamp nut, No.1 washer and gasket up to No. 2 washer, slide on
No.2
Slide clamp nut, No.1 washer, gasket and No.2 washer over cable.
Trim cable to dimension shown taking care not to nick the braid.
Thumb braid out radially at right angles to dielectric.
A small chamfer may now be cut on the end of cable dielectric, to assist
assembly of sleeve.
Slide sleeve over cable dielectric and under braid and outer jacket until
the flange of the sleeve is flush against the braid.
Move No. 2 washer up to braid and trim braid flush with the flange of
the sleeve.
Trim cable dielectric and center conductor to dimensions shown taking
care not to nick the center conductor.
Tin center conductor (DO NOT OVER TIN).
Slide rear insulator over cable.
swg) multi-core sodler in rear of contact.
conductor and push until the shoulder of the contact is flush against the
rear insulator. Do not allow solder to protrude outside spill hole.
assembled in body).
front body and tighten clamp nut to required torque: 0,63 - 0,70 Nm (90-
100 in. ozs.)
Only common cable retention features are shown in detail. Various body
configurations can apply.
SLEEVE
52
INSULATOR
REAR
CONTACT
ASSEMBLY INSTRUCTIONS
Specifications and dimensions subject to change
INSULATOR
FRONT
Dimensions shown in mm (inch)
www.ittcannon.com
FRONT
BODY