XR21V1410IL-0B-EB Exar Corporation, XR21V1410IL-0B-EB Datasheet - Page 8

• Manufacturer Part Number: XR21V1410IL-0B-EB
• Description: Interface Modules & Development Tools For XR21V1410 QFN16 USB, RS232;No Cables
• Manufacturer: Exar Corporation
• Series: -r

Specifications of XR21V1410IL-0B-EB

• Interface Type: RS-232, USB
• Operating Supply Voltage: 3.3 V
• Product: Interface Modules
• Silicon Core Number: XR21V1410
• Application Sub Type: UART
• Kit Contents: Board
• Main Purpose: Interface, USB 2.0 to UART
• Embedded: No
• Utilized Ic / Part: XR21V1410IL
• Primary Attributes: -
• Secondary Attributes: -
• Silicon Manufacturer: Exar
• Kit Application Type: Communication & Networking
• For Use With/related Products: XR21V1410
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

XR21V1410
1-CH FULL-SPEED USB UART
Error flags are also available from the ERROR_STATUS register and the interrupt packet, however these flags
are historical flags indicating that an error has occurred since the previous read of the status register.
Therefore, no conclusion can be drawn as to which specific byte(s) may have contained an actual error in this
manner.
There are 6 GPIOs. By default, the GPIOs are general purpose I/Os. However, there are few modes that can
be enabled to add additional feature such as Auto RTS/CTS Flow control, Auto DTR/DSR Flow Control or
Transceiver Enable Control. See
GPIO5 and GPIO4 of the UART channel can be enabled as the RTS# and CTS# signals for Auto RTS/CTS
flow control when GPIO_MODE[2:0] = ’001’ and FLOW_CONTROL[2:0] = ’001’. Automatic RTS flow control is
used to prevent data overrun errors in local RX FIFO by de-asserting the RTS signal to the remote UART.
When there is room in the RX FIFO, the RTS pin will be re-asserted. Automatic CTS flow control is used to
prevent data overrun to the remote RX FIFO. The CTS# input is monitored to suspend/restart the local
transmitter (see
1.5.3
1.5.4
GPIO
Automatic RTS/CTS Hardware Flow Control
2nd byte
2nd byte
1st byte
1st byte
Figure
4):
7 6 5 4 3 2 1 0
7 6 5 4 3 2 1 0
x x x x O F B P
x x x x O F B 8
7 or 8 bit m ode
Table
9 bit m ode
F
IGURE
14.
3. R
ECEIVE
8
D
B = B reak
F = Fram ing E rror
B = B reak
F = Fram ing E rror
O = O verrun E rror
P = P arity E rror (= ‘0’ if not enabled)
x = ‘0’
O = O verrun E rror
ATA
x = ‘0’
7 = ‘0’ in 7 bit m ode
F
ORMAT
REV. 1.2.0