GT3F-1AD24 IDEC, GT3F-1AD24 Datasheet - Page 26

• Manufacturer Part Number: GT3F-1AD24
• Description: GT3F-1AD24 8PIN DPDT TRUE POWER OFF DELAY TIMER
• Manufacturer: IDEC

830
Inputs of GT3F
To avoid electric shock, do not touch the input signal terminal during power voltage application.
Never apply the input signals to two or more GT3F timers using the same contact or transistor.
[Incorrect]
Input
Contact or Transistor
In a transistor circuit for controlling input signals, with its primary and secondary power circuits isolated, do not ground the secondary circuit.
On the GT3F timers, connect the input signals to terminal No.1 and 4 only on the 8-pin type; connect the input signals to terminal No. 6 and 7 only on the 11-pin type.
Never apply voltage to other terminals; otherwise, the internal circuit may be damaged.
Input signal lines must be made as short as possible and installed away from power cables and power lines. Use shielded wires or a separate conduit for input wir-
ing.
The GT3F, consisting of a high-impedance circuit, may not be reset due to the infl uence of an inductive voltage or residual voltage caused by a leakage current. If not
reset, connect an RC fi lter or bleeder resistor between power terminals so that the voltage between power terminals can be reduced to less than 15% of the rated
voltage.
Insulating Transformer
2
2
Circuit
GT3 Series
Timer
Input
Terminal
Input
Terminal
GT3 Series
Timer
Input
Terminal
10
10
GT3F Series
Power
Power
[correct]
2
2
Input
Terminal
Input
Terminal
Instructions: Wiring Inputs
10
10
www.idec.com
Power
Timers