LM1894MT National Semiconductor, LM1894MT Datasheet - Page 3
LM1894MT
Manufacturer Part Number
LM1894MT
Description
Manufacturer
National Semiconductor
Datasheet
1.LM1894MT.pdf
(12 pages)
Specifications of LM1894MT
Lead Free Status / RoHS Status
Not Compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Gain Amplifier Input Impedance
Peak Detector Input Impedance
Voltage Gain
Attack Time
Decay Time
DC Voltage Range
Electrical Characteristics
V
Voltage Gain
Note 2: For operation in ambient temperature above 25˚C, the device must be derated based on a 150˚C maximum junction temperature and a thermal resistance
of 1) 80˚C/W junction to ambient for the dual-in-line package, 2) 105˚C/W junction to ambient for the small outline package, and 3) 150˚C/W junction to ambient for
the TSSOP package.
Note 3: To force the DNR system into maximum bandwidth, DC ground the input to the peak detector, pin 9. A negative temperature coefficient of −0.5%/˚C on the
bandwidth, reduces the maximum bandwidth at increased ambient temperature or higher package dissipation. AC ground pin 9 or pin 6 to select minimum
bandwidth. To change minimum and maximum bandwidth, see Appliction Hints.
Note 4: The maximum noise reduction CCIR/ARM weighted is about 14 dB. This is accomplished by changing the bandwidth from maximum to minimum. In actual
operation, minimum bandwidth is not selected, a nominal minimum bandwidth of about 2 kHz gives −10 dB of noise reduction. See Application Hints.
Note 5: The CCIR/ARM weighted noise is measured with a 40 dB gain amplifier between the DNR system and the CCIR weighting filter; it is then input referred.
Note 6: Measured using the Rhode-Schwartz psophometer.
Note 7: Pin 10 is DC forced half way between the maximum bandwidth DC level and minimum bandwidth DC level. An AC 1 kHz signal is then applied to pin 10.
Its peak-to-peak amplitude is V
S
= 8V, T
A
= 25˚C, V
Parameter
IN
DC
= 300 mV at 1 kHz, circuit shown in Figure 1 unless otherwise specified
(max BW) − V
DC
(min BW).
Pin 6
Pin 6 to Pin 8
Pin 9
Pin 9 to Pin 10
Measured to 90% of Final Value
with 10 kHz Tone Burst
Measured to 90% of Final Value
with 10 kHz Tone Burst
Minimum Bandwidth to Maximum
Bandwidth
(Continued)
Conditions
3
21.5
Min
560
300
1.1
24
30
45
Typ
700
500
30
24
33
60
Max
26.5
840
700
3.8
39
36
75
www.national.com
Units
V/V
V/V
kΩ
ms
µs
Ω
V