ADF4360-6BCPRL7 Analog Devices Inc, ADF4360-6BCPRL7 Datasheet - Page 17

• Manufacturer Part Number: ADF4360-6BCPRL7
• Description: IC INTEG SYNTH/VCO 24-LFCSP T/R
• Manufacturer: Analog Devices Inc
• Type: Fanout Distribution, Integer N Synthesizer (RF)r

Specifications of ADF4360-6BCPRL7

• Rohs Status: RoHS non-compliant
• Pll: Yes
• Input: CMOS
• Output: Clock
• Number Of Circuits: 1
• Ratio - Input:output: 1:2
• Differential - Input:output: No/No
• Frequency - Max: 1.25GHz
• Divider/multiplier: Yes/No
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 24-LFCSP
• Frequency-max: 1.25GHz
• For Use With: EVAL-ADF4360-6EBZ1 - BOARD EVALUATION FOR ADF4360-6

Hardware Power-Up/Power-Down
If the part is powered down via the hardware (using the CE pin)
and powered up again without any change to the N counter
register during power-down, the part locks at the correct fre-
quency because the part is already in the correct frequency
band. The lock time depends on the value of capacitance on the
C
pacitance of 440 nF on this pin enables lock times of <600 µs.
The N counter value cannot be changed while the part is in
power-down because the part may not lock to the correct fre-
quency on power-up. If it is updated, the correct programming
sequence for the part after power-up is to the R counter latch,
followed by the control latch, and finally the N counter latch,
with the required interval between the control latch and N
counter latch, as described in the Initial Power-Up section.
N
pin, which is <5 ms for 10 µF capacitance. The smaller ca-
Rev. A | Page 17 of 24
Software Power-Up/Power-Down
If the part is powered down via the software (using the control
latch) and powered up again without any change to the N
counter latch during power-down, the part locks at the correct
frequency because the part is already in the correct frequency
band. The lock time depends on the value of capacitance on the
C
pacitance of 440 nF on this pin enables lock times of <600 µs.
The N counter value cannot be changed while the part is in
power-down because the part may not lock to the correct fre-
quency on power-up. If it is updated, the correct programming
sequence for the parts after power-up is to the R counter latch,
followed by the control latch, and finally the N counter latch,
with the required interval between the control latch and N
counter latch, as described in the Initial Power-Up section.
N
pin, which is <5 ms for 10 µF capacitance. The smaller ca-
ADF4360-6