LTC1603CG Linear Technology, LTC1603CG Datasheet - Page 6

• Manufacturer Part Number: LTC1603CG
• Description: IC ADC W/SHUTDOWN 16BIT 36-SSOP
• Manufacturer: Linear Technology

Specifications of LTC1603CG

• Number Of Bits: 16
• Sampling Rate (per Second): 250k
• Data Interface: Parallel
• Number Of Converters: 1
• Power Dissipation (max): 350mW
• Voltage Supply Source: Analog and Digital, Dual ±
• Operating Temperature: 0°C ~ 70°C
• Mounting Type: Surface Mount
• Package / Case: 36-SSOP (0.200", 5.30mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

PIN
A
difference voltage between A
tial range of 2.5V. A
A
A
to a DC voltage or driven differentially with A
V
2.2 F tantalum in parallel with 0.1 F ceramic.
REFCOMP (Pin 4): 4.375V Reference Compensation Pin.
Bypass to AGND with 47 F tantalum in parallel with 0.1 F
ceramic.
AGND (Pins 5 to 8): Analog Grounds. Tie to analog ground
plane.
DV
with 10 F tantalum in parallel with 0.1 F ceramic.
DGND (Pin 10): Digital Ground for Internal Logic. Tie to
analog ground plane.
D15 to D0 (Pins 11 to 26): Three-State Data Outputs. D15
is the Most Significant Bit.
BUSY (Pin 27): The BUSY output shows the converter
status. It is low when a conversion is in progress. Data is
valid on the rising edge of BUSY.
LTC1603
6
IN
IN
IN
REF
DD
U
+
–
–
(Pin 2): Negative Analog Input. Can be grounded, tied
(Pin 1): Positive Analog Input. The ADC converts the
(Pin 3): 2.5V Reference Output. Bypass to AGND with
is grounded.
(Pin 9): 5V Digital Power Supply. Bypass to DGND
FUNCTIONS
U
U
IN
+
has a 2.5V input range when
IN
+
and A
IN
–
with a differen-
IN
+
.
OGND (Pin 28): Digital Ground for Output Drivers.
OV
Bypass to OGND with 10 F tantalum in parallel with 0.1 F
ceramic.
RD (Pin 30): Read Input. A logic low enables the output
drivers when CS is low.
CONVST (Pin 31): Conversion Start Signal. This active
low signal starts a conversion on its falling edge when CS
is low.
CS (Pin 32): The Chip Select Input. Must be low for the
ADC to recognize CONVST and RD inputs.
SHDN (Pin 33): Power Shutdown. Drive this pin low with
CS low for nap mode. Drive this pin low with CS high for
sleep mode.
V
10 F tantalum in parallel with 0.1 F ceramic.
AV
with 10 F tantalum in parallel with 0.1 F ceramic.
AV
with 10 F tantalum in parallel with 0.1 F ceramic and
connect this pin to Pin 35 with a 10 resistor.
SS
DD
DD
DD
(Pin 34): – 5V Negative Supply. Bypass to AGND with
(Pin 35): 5V Analog Power Supply. Bypass to AGND
(Pin 36): 5V Analog Power Supply. Bypass to AGND
(Pin 29): Digital Power Supply for Output Drivers.
1603f