20-101-1215 Rabbit Semiconductor, 20-101-1215 Datasheet - Page 49

• Manufacturer Part Number: 20-101-1215
• Description: MCU RCM4050 RABBITCORE
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1215

• Module/board Type: MPU Core Module
• For Use With/related Products: RCM4050
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1145

4.5 Other Hardware
4.5.1 Clock Doubler
The RCM4000 takes advantage of the Rabbit 4000 microprocessor’s internal clock doubler.
A built-in clock doubler allows half-frequency crystals to be used to reduce radiated
emissions. The 58.98 MHz frequency specified for the RCM4000 is generated using a
29.49 MHz crystal.
The clock doubler may be disabled if 58.98 MHz clock speeds are not required. Disabling
the Rabbit 4000 microprocessor’s internal clock doubler will reduce power consumption
and further reduce radiated emissions. The clock doubler is disabled with a simple config-
uration macro as shown below.
4.5.2 Spectrum Spreader
The Rabbit 4000 features a spectrum spreader, which helps to mitigate EMI problems. The
spectrum spreader is on by default, but it may also be turned off or set to a stronger setting.
The means for doing so is through a simple configuration macro as shown below.
User’s Manual
1. Select the “Defines” tab from the Dynamic C
2. Add the line CLOCK_DOUBLED=0 to always disable the clock doubler.
3. Click
1. Select the “Defines” tab from the Dynamic C
2. Normal spreading is the default, and usually no entry is needed. If you need to specify
3. Click
The clock doubler is enabled by default, and usually no entry is needed. If you need to
specify that the clock doubler is always enabled, add the line CLOCK_DOUBLED=1 to
always enable the clock doubler.
in the project file where you defined the macro.
normal spreading, add the line
For strong spreading, add the line
To disable the spectrum spreader, add the line
in the project file where you defined the macro.
ENABLE_SPREADER=1
ENABLE_SPREADER=2
ENABLE_SPREADER=0
NOTE: Refer to the Rabbit 4000 Microprocessor User’s Manual for more information
NOTE: The strong spectrum-spreading setting is not recommended since it may limit
OK
OK
on the spectrum-spreading setting and the maximum clock speed.
the maximum clock speed or the maximum baud rate. It is unlikely that the strong set-
ting will be used in a real application.
to save the macro. The clock doubler will now remain off whenever you are
to save the macro. The clock doubler will now remain off whenever you are
Options > Project Options
Options > Project Options
menu.
menu.
43