USB3300-EZK SMSC, USB3300-EZK Datasheet - Page 13

• Manufacturer Part Number: USB3300-EZK
• Description: IC USB HOST/OTG PHY ULPI 32-QFN
• Manufacturer: SMSC
• Type: Hi Speed USB Host Devicer

Specifications of USB3300-EZK

• Controller Type: USB 2.0 Controller
• Interface: USB
• Voltage - Supply: 3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 32-QFN
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Supply: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 638-1034

Hi-Speed USB Host, Device or OTG PHY with ULPI Low Pin Interface
Datasheet
SMSC USB3300
PIN
30
31
32
GND FLAG
REG_EN
VDD3.3
RBIAS
NAME
Table 3.1 USB3300 Pin Definitions 32-Pin QFN Package (continued)
DIRECTION,
Pull-low
Analog,
Ground
CMOS,
CMOS
Power
TYPE
I/O,
DATASHEET
ACTIVE
LEVEL
N/A
N/A
N/A
N/A
13
DESCRIPTION
Analog 3.3 volt supply. A 0.1uF low ESR bypass
capacitor connected to the ground plane of the PCB
is recommended.
On-Chip 1.8V regulator enable. Connect to ground to
disable both of the on chip (VDDA1.8 and VDD1.8)
regulators. When regulators are disabled:
External 12KΩ +/- 1% bias resistor to ground.
Ground. The flag must be connected to the ground
plane with a via array under the exposed flag. This
is the main ground for the IC.
External 1.8V must be supplied to VDDA1.8 and
VDD1.8 pins. When the regulators are disabled,
VDDA1.8 may be connected to VDD1.8 and a
bypass capacitor (0.1uF recommended) should be
connected to each pin.
The voltage at VDD3.3 must be at least 2.64V (0.8
* 3.3V) before voltage is applied to VDDA1.8 and
VDD1.8.
Revision 1.08 (11-07-07)