SU2200RMXLTNET APC, SU2200RMXLTNET Datasheet - Page 22

• Manufacturer Part Number: SU2200RMXLTNET
• Description: UPS - Uninterruptible Power Supplies APC Smart-UPS XL 2200VA RM 5U 208V
• Manufacturer: APC

Specifications of SU2200RMXLTNET

• Power Rating: 1600 W
• Output Voltage Rating: 208 V
• Number Of Outlets: 5
• Interface Port: DB-9 RS-232, SmartSlot
• Runtime (full Load): 10 min
• Runtime (half Load): 34 min
• Topology: Online
• Tower / Rackmount: Rackmount
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

5. Pull the panel out gently so that the 3-pin
6. Squeeze the locking tabs on the sides of the connectors and pull
7. Disconnect the two wires from the rear of the circuit breaker on
8. If the serial number decal is located on the output panel, remove it
9. Discard the output panel.
Remove the Input Panel
NOTE:
1. Remove the two bottom screws from the input panel as shown in
2. Unplug the 4-pin input connector
3. Save the screws. They will be used to install the replacement panel.
4. Discard the input panel and cord.
20
the connectors apart. Do not pull on the wires.
the output panel. Working from the front side of the output panel,
use a small screwdriver to apply pressure to the side of the circuit
breaker and push it free of the panel. Save the circuit breaker for
reinstallation into the new output panel.
and replace it on the permanent, upper panel on the back of the
UPS.
Figure 5-10.
cation of the input connection.
in-line connectors are accessible.
If you are hard wiring only the output, skip this section and
continue with Section 5.2.2.
as shown below. Note the lo-
, 4-pin
, and 4-pin