ASI PROGRAMMER V2.0 ZMD, ASI PROGRAMMER V2.0 Datasheet - Page 7

• Manufacturer Part Number: ASI PROGRAMMER V2.0
• Description: PROGRAMMER, AS-INTERFACE
• Manufacturer: ZMD

Specifications of ASI PROGRAMMER V2.0

• Ic Product Type: Programmer
• Development Tool Type: Development Board
• Interface Type: CMOS, RS232
• Kit Features: ZMD's AS-Interface IC EEPROM, Open Serial Protocol Control, Integrated AS-I Power Generation
• Rohs Compliant: Yes

AS –Interface Programmer
User Manual
2.2.2
2.2.3
This module allows to control an AS-Interface network (up to 62 slave modules) bit by bit. Graphical
Input Output control runs in a loop mode for permanent data exchange with all slaves. The data
transfer rate between programmer and slave modules does not reachs ASi real-time mode. The speed
of data exchange depends on the PC performance. The minimum cycle time for data exchange with 1
slave is approximately 5,4ms.
Note: Resulting of the slower ASi Programmer cycle time a communication error with
Handling:
Rev. 1.08, Copyright © 2005, ZMD AG
All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without the prior written consent of the copyright
owner. The Information furnished in this publication is preliminary and subject to changes without notice.
Graphical Input Output
control
1. Click on “Read Network Configuration” to detect the connected Slaves
2. Click on “Write Parameter” for parameterisation of all detected slave modules. To modify the
3. In order to support the 4 In put / 4 Output mode (4I4O), described in the AS-I Complete
4. A Click on „Run“ will start the loop mode for continuous data exchange (non ASi real-time
Main window
Graphical Input Output Control
connected modules may provoked if the ASi module Watchdog activation flag
is set.
parameter file click on “Change Parameter File” button. Otherwise default parameters
(&B0000) may used.
Specification 3.0, this mode can be activated for all slaves in extended address mode
separately. The special nibble selected transfer protocol (chapter 5.7.4.1 in Complete
Specification). To activate this feature in slave modules, the corresponding EEPROM bit has
to be programmed further.
mode!). The loop counter shows the number of completed network data exchange cycles.
Manual network / slave
control
Address
Management
EEPROM programming
7/17