SNAP-TEX-REC10N OPTO 22, SNAP-TEX-REC10N Datasheet - Page 4

• Manufacturer Part Number: SNAP-TEX-REC10N
• Description: 40T0078
• Manufacturer: OPTO 22

Specifications of SNAP-TEX-REC10N

• Accessory Type: Narrow End Cap

PAGE
4
Installing the SNAP-ROKDIN Adapter Kit
This adapter kit is for the SNAP-PAC-SRA arbiter or the SNAP-RPSW
redundant power switch. The DIN-rail clip adds an additional 0.375
inches (0.95 cm) to the device’s height. You need one adapter kit
per device.
1. Turn the device over. Unscrew the four flat-head screws and
2. Attach the new, plain base plate to the device using the saved
3. Align the DIN-rail clip to the new base plate so that the spring
4. To mount, align the spring clip with the bottom edge of the DIN
Opto 22 • 43044 Business Park Drive • Temecula, CA 92590-3614 • www.opto22.com
SALES 800-321-6786 • 951-695-3000 • FAX [phone] • [e-mail] • SUPPORT 800-835-6786 • 951-695-3080 • FAX [phone] • [e-mail]
© 2008–2010 Opto 22. All rights reserved. Dimensions and specifications are subject to change. Brand or product names used herein are trademarks or registered trademarks of their respective companies or organizations.
remove the base plate. Save the screws.
screws.
will be at the bottom of the device when it is mounted on the
DIN rail. Use the two round-head screws provided with the kit
to attach the clip..
rail, push up to engage the spring, and slip the two top flanges
over the top edge of the DIN rail.
SNAP TEX Mounting/Wiring Tools and Spare Parts
Wiring Accessories
Jumper Straps for SNAP Digital I/O
SNAP I/O module jumper straps let you easily make jumper
connections on a SNAP digital I/O module.
The SNAP-STRAP plugs into individual wire connections on a
module’s pluggable field connector. SNAP-STRAPs on multiple
modules can be connected using the SNAP-WIRESTRAP.
Both parts are Factory Mutual approved.
For other wiring options, see form #1756, the SNAP TEX Cables and
Breakout Boards Data Sheet.
Replacement Parts
The SNAP-FIELDCONB replaces a lost or damaged field connector.
It plugs into the top of a SNAP I/O module and is used for wiring
field devices to the module. Used with most 1-, 2-, and 4-channel
digital and analog modules, it accepts up to 14 AWG wire. Torque
specifications for connector screws: 5.26 inch lbs (0.6 Newton m.)
The SNAP-MR10 is a replacement mechanical relay (10 A) and clip
for SNAP-TEX-MR10-16 and SNAP-TEX-MR10-4 breakout boards.
Typical life expectancy (Electrical): 1 x 10
Length of wire between connectors = 3.25" (8.26 cm)
5
.