030-2416-001 ITT Cannon, LLC, 030-2416-001 Datasheet - Page 58

• Manufacturer Part Number: 030-2416-001
• Description: DL CONT CRIMP 28-32 20AU
• Manufacturer: ITT Cannon, LLC
• Series: DLr
• Type: Signalr

Specifications of 030-2416-001

• Pin Or Socket: Non-Gendered
• Contact Termination: Crimp
• Wire Gauge: 28-32 AWG
• Contact Finish: Gold
• Contact Finish Thickness: 20µin (0.51µm)
• Current Rating: -
• Lead Free Status / Rohs Status: Contains lead / RoHS non-compliant
• For Use With: 1003-1679 - DLM 156C SHILDED PLUG1003-1680 - DLM 96C SHIELDED PLUG1003-1681 - DLM 96C SHIELDED RECPT
• Other names: 030-2416-001; 302416001; I030-2416-001; I030-2416-001

ZIF Connectors
Tools and Assembly
Assembly Instructions for Buss Contacts
Contact Insertion:
All buss contacts are inserted by hand. No tooling
is required for either the plug or receptacle.
RECEPTACLE
CONNECTOR
Caution:
Caution: Do not force contacts into contact
cavities.
If
contact
encounters
excessive
resistance during installation remove and re-insert
RETENTION
LANCE
using a slight up and down motion. This will assure
PLUG
(BOTTOM)
CONNECTOR
positive cavity alignment. Do not install contact if
plug is in the closed or actuated position.
RETENTION
Plug:
LANCE
(TOP)
Step 1. Prior to inserting contacts, turn the shaft
RETENTION
LANCE
counter-clockwise to its maximum open position.
(TOP)
Step 2. With the retention lance positioned away
from the shaft, insert contacts from the rear of the
plug.
SCREW
Receptacle:
Step 1. With the retention lance positioned toward
CAM
the shaft hole, insert contacts from the rear of the
receptacle.
POLARIZING
POST
RETENTION
LANCE
(BOTTOM)
Contact Removal for Buss Contacts
Tool: CET-DL3/4/5/6
CONTACT
RETENTION
LANCE
Release retention lance by inserting tip of
extraction tool into cavity until it bottoms on
insulator shoulder. Gently remove buss contact in
direction of arrow, see illustration, to remove
CONTACT
contact from insulator.
RETENTION
LANCE
Dimensions are shown in mm (inch)
57
Dimensions subject to change