ADUC834 Analog Devices, ADUC834 Datasheet - Page 39

• Manufacturer Part Number: ADUC834
• Description: Precision Analog Microcontroller: 1MIPS 8052 MCU + 62kB Flash + 16/24-Bit ADC + 12-Bit DAC
• Manufacturer: Analog Devices

Specifications of ADUC834

• Mcu Core: 8052
• Mcu Speed (mips): 1
• Sram (bytes): 2304Bytes
• Gpio Pins: 34
• Adc # Channels: 4
• Other: PWM

ON-CHIP PLL
The ADuC834 is intended for use with a 32.768 kHz watch
crystal. A PLL locks onto a multiple (384) of this to provide a
stable 12.582912 MHz clock for the system. The core can oper-
ate at this frequency, or at binary submultiples of it, to allow
power saving in cases where maximum core performance is not
PLLCON
SFR Address
Power-On Default Value
Bit Addressable
Bit
7
6
5
4
3
2
1
0
REV. A
Name
OSC_PD
LOCK
–––
LTEA
FINT
CD2
CD1
CD0
PLL Control Register
D7H
No
Description
Oscillator Power-Down Bit.
Set by user to halt the 32 kHz oscillator in power-down mode.
Cleared by user to enable the 32 kHz oscillator in power-down mode.
This feature allows the TIC to continue counting even in power-down mode.
PLL Lock Bit. This is a read-only bit.
Set automatically at power-on to indicate the PLL loop is correctly tracking the crystal clock. After
power down, this bit can be polled to wait for the PLL to lock.
Cleared automatically at power-on to indicate the PLL is not correctly tracking the crystal clock.
This may be due to the absence of a crystal clock or an external crystal at power-on. In this mode,
the PLL output can be 12.58 MHz ± 20%. After the ADuC834 wakes up from power-down,
user code may poll this bit, to wait for the PLL to lock. If LOCK = 0, then the PLL is not locked.
Reserved for Future Use; Should Be Written with ‘0’
Reading this bit returns the state of the external EA pin latched at reset or power-on.
Fast Interrupt Response Bit.
Set by user enabling the response to any interrupt to be executed at the fastest core clock frequency,
regardless of the configuration of the CD2–0 bits (see below). After user code has returned from an
interrupt, the core resumes code execution at the core clock selected by the CD2–0 bits.
Cleared by user to disable the fast interrupt response feature.
CPU (Core Clock) Divider Bits.
This number determines the frequency at which the microcontroller core will operate.
CD2
0
0
0
0
1
1
1
1
03H
Table XVII. PLLCON SFR Bit Designations
CD1
0
0
1
1
0
0
1
1
CD0
0
1
0
1
0
1
0
1
–39–
required. The default core clock is the PLL clock divided by 8
or 1.572864 MHz. The ADC clocks are also derived from the
PLL clock, with the modulator rate being the same as the crys-
tal oscillator frequency. The above choice of frequencies ensures
that the modulators and the core will be synchronous, regardless
of the core clock rate. The PLL control register is PLLCON.
Core Clock Frequency (MHz)
12.582912
6.291456
3.145728
1.572864 (Default Core Clock Frequency)
0.786432
0.393216
0.196608
0.098304
ADuC834