STR750FV2 STMicroelectronics, STR750FV2 Datasheet - Page 53

• Manufacturer Part Number: STR750FV2
• Description: ARM7TDMI-S™ 32-BIT MCU with Flash, SMI, 3 std 16-bit timers, PWM timer, fast 10-bit ADC, I2C, UART, SSP, USB and CAN
• Manufacturer: STMicroelectronics

Specifications of STR750FV2

• Smart Low Power Modes: SLOW, WFI, STOP and STANDBY with backup registers
• Conversion Time: min. 3.75 μs

STR750Fxx STR751Fxx STR752Fxx STR755Fxx
Static and dynamic latch-up
●
●
Table 31.
1. Class description: A Class is an STMicroelectronics internal specification. All its limits are higher than the
Symbol
JEDEC specifications, that means when a device belongs to Class A it exceeds the JEDEC standard. B
Class strictly covers all the JEDEC criteria (international standard).
DLU
LU
LU: 3 complementary static tests are required on 10 parts to assess the latch-up
performance. A supply overvoltage (applied to each power supply pin) and a current
injection (applied to each input, output and configurable I/O pin) are performed on each
sample. This test conforms to the EIA/JESD 78 IC latch-up standard. For more details,
refer to the application note AN1181.
DLU: Electro-Static Discharges (one positive then one negative test) are applied to
each pin of 3 samples when the micro is running to assess the latch-up performance in
dynamic mode. Power supplies are set to the typical values, the oscillator is connected
as near as possible to the pins of the micro and the component is put in reset mode.
This test conforms to the IEC1000-4-2 and SAEJ1752/3 standards. For more details,
refer to the application note AN1181.
Static latch-up class
Dynamic latch-up class
Electrical sensitivities
Parameter
T
T
T
V
f
CK_SYS
A
A
A
DD
=+25° C
=+85° C
=+105° C
= 5.5 V, f
=32 MHz, T
OSC4M
Conditions
=4 MHz,
A
=+25° C
Electrical parameters
Class
Class A
Class A
(1)
53/84