KTS 6027-2 Infineon Technologies, KTS 6027-2 Datasheet - Page 16

• Manufacturer Part Number: KTS 6027-2
• Description: IC TUNER MOPLL ANALOG 28-TSSOP
• Manufacturer: Infineon Technologies
• Type: Tunerr
• Series: OMNITUNE™r

Specifications of KTS 6027-2

• Package / Case: 28-TSSOP
• Applications: NTSC, PAL
• Mounting Type: Surface Mount
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 20 C
• Mounting Style: SMD/SMT
• Packages: PG-TSSOP-28
• Vs (min): 4.5 V
• Vs (max): 5.5 V
• Icc (max): 79.0 mA
• Esd Protection (max): 2.0 kV
• Mounting: SMT
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: SP000013185

Wireless Components
3.4.1
3.4.2
3.4.3
3.4 Circuit Description
General
In the normal mode (
KTS6027-S / KTS6029-S. An extended mode makes a reference divider ratio
of 24 (
currents (
Mixer-Oscillator block
The mixer oscillator section includes two balanced mixers (double balanced
mixer), two balanced oscillators for LOW and / or MID band and HIGH band, an
IF amplifier, a reference voltage source and a band switch.
Filters between tuner input and IC separate the TV frequency signals into two
bands. The band switching in the tuner front-end is done by using two or three
port outputs. In the selected band the signal passes a tuner input stage with
MOSFET amplifier, a double-tuned bandpass filter and is then fed to the bal-
anced mixer input of the IC which has in case of LOW / MID a high-impedance
input and in case of HIGH a low-impedance input. The input signal is mixed
there with the signal from the activated on chip oscillator to the IF frequency
which is filtered out at the balanced high-impedance output pair by means of a
parallel tuned circuit. The following SAW preamplifier has a low output imped-
ance to drive the SAW filter directly.
PLL block
The oscillator signal is internally DC-coupled as a differential signal to the pro-
grammable divider inputs. The signal subsequently passes through a program-
mable divider with ratio N = 256 through 32767 and is then compared in a digital
frequency / phase detector to a reference frequency f
166.7 kHz.
This frequency is derived from an unbalanced, low-impedance 4 MHz crystal
oscillator (pin XTAL) divided by R = 128, 80, 64 or 24.
The phase detector has two outputs that drive two current sources of opposite
polarity as charge pump. If the negative edge of the divided VCO signal appears
prior to the negative edge of the reference signal, the positive current source
pulses for the duration of the phase difference. In the reverse case the negative
current source pulses. If the two signals are in phase, the charge pump output
(CP) goes into the high-impedance state (PLL is locked). An active low-pass fil-
ter integrates the current pulses to generate the tuning voltage for the VCO
see Table 5-8 Reference divider ratio on page 32
see Table 5-9 Charge pump current on page 33
see Table 5-7 Test modes on page 32
3 - 9
) and two additional charge pump
) available.
KTS6027-2, KTS6029-2
) the IC is compatible with
ref
Functional Description
= 31.25, 50, 62.5 or
Specification, July 2001