MB3874 Fujitsu Media Devices, MB3874 Datasheet - Page 15

• Manufacturer Part Number: MB3874
• Description: DC/DC Converter IC for Parallel Charging
• Manufacturer: Fujitsu Media Devices

1. DC/DC Converter Unit
(1) Reference voltage block (Ref)
(2) Triangular wave oscillator block (OSC)
(3) Error amplifier block (Error Amp.1)
(4) Error amplifier block (Error Amp.2, 3)
(5)
(6) Current detector amplifier block (Current Amp.1, 2)
FUNCTIONAL DESCRIPTION
The reference voltage generator uses the voltage supplied from the Vcc terminal (pin 21) to generate a temper-
ature-compensated, stable voltage ( : = 4.2 V) used as the reference supply voltage for the IC’s internal circuitry.
The reference voltage can be output, up to 1 mA, to an external device through the VREF terminal (pin 5).
The triangular wave oscillator generates a triangular waveform with a frequency setting resistor connected to
the internal frequency setting capacitor via the RT terminal (pin 17).
The triangular wave is input to the PWM comparator on the IC.
This error amplifier (Error Amp.1) detects a voltage drop in the AC adapter and outputs a PWM control signal
as well as a signal to the dynamically controlled charging detection block (MASK Comp.).
In addition, an arbitrary loop gain can be set by connecting a feedback resistor and capacitor from the FB1
terminal (pin 7) to the INE1 terminal (pin 8) of the error amplifier, enabling stable phase compensation to the
system.
These error amplifiers (Error Amp.2, Error Amp.3) detect the output signals from the current detector amplifiers
(Current Amp.1, Current Amp.2), compare them with the +INE2 terminal (pin 4) and +INE3 terminal (pin 9), and
output PWM control signals to control the charge current.
In addition, these amplifiers allow an arbitrary loop gain to be set by connecting a feedback resistor and capacitor
from the FB2 terminal (pin 2) to INE2 terminal (pin 3) and from the FB3 terminal (pin 11) to INE3 terminal (pin
10) of the error amplifiers, enabling stable phase compensation to the system.
This error amplifier (Error Amp.4, Error Amp.5) detects the output voltage from the switching rerulator and outputs
the PWM control signal. The error amplifier inverted input pin is connected to the output voltage setting resistor
in the IC, eliminating the need for an external resistor for setting the output voltage. The MB3874 and MB3876
are set to output voltage of 12.6 V (for a 3-cell battery) and 16.8 V (for a 4-cell battery), respectively; these ICs
are suitable for use in equipment that uses a lithium-ion battery.
In addition, an arbitrary loop gain can be set by connecting a feedback resistor and capacitor from the FB4
terminal (pin 15) to the INE4 terminal (pin 16) to the INE5 terminal (pin 14) of the error amplifier, enabling
stable phase compensation to the system.
Connecting a soft-start capacitor to the CS terminal (pin 22) prevents surge currents when the IC is turned on.
Using an error amplifier for soft start detection makes the soft start time constant, independent of the output load.
The current detection amplifier (Current Amp.1, Current Amp.2) detects a voltage drop which occurs between
both ends of the output sense resistor (RS1) due to the flow of the charge current, using the +INC1 terminal
(pin 24) and
the next stage.The amplifiers also detect a voltage drop which occurs at both ends of the output sense resistor
INC1 terminal (pin 1). Then it outputs the signal amplified by 25 times to the error amplifier (Error Amp.2) at
Error amplifier block (Error Amp.4, 5)
MB3874/MB3876
15