T140VN01 AU_OPTRONICS, T140VN01 Datasheet - Page 25

• Manufacturer Part Number: T140VN01
• Description: COLOR TFT LCD MODULE
• Manufacturer: AU_OPTRONICS

PDF created with FinePrint pdfFactory Pro trial version
©Copyright AU Optronics, Inc.
January, 2003 All Rights Reserved.
No Reproduction and Redistribution Allowed.
9. PRECAUTIONS
Please pay attention to the followings when you use this TFT LCD module.
9-1 MOUNTING PRECAUTIONS
(1) You must mount a module using holes arranged in four corners or four sides.
(2) You should consider the mounting structure so that uneven force (ex. Twisted stress) is not
(3) Please attach the surface transparent protective plate to the surface in order to protect the
(4) You should adopt radiation structure to satisfy the temperature specification.
(5) Acetic acid type and chlorine type materials for the cover case are not desirable because the
(6) Do not touch, push or rub the exposed polarizers with glass, tweezers or anything harder than
(7) When the surface becomes dusty, please wipe gently with absorbent cotton or other soft
(8) Wipe off saliva or water drops as soon as possible. Their long time contact with polarizer
(9) Do not open the case because inside circuits do not have sufficient strength.
9-2 OPERATING PRECAUTIONS
(1) The spike noise causes the mis-operation of circuits. It should be lower than following voltage:
(2) Response time depends on the temperature. (In lower temperature, it becomes longer..)
(3) Brightness depends on the temperature. (In lower temperature, it becomes lower.) And in
(4) Be careful for condensation at sudden temperature change. Condensation makes damage to
applied to module. And the case on which a module is mounted should have sufficient strength
so that external force is not transmitted directly to the module.
polarizer. Transparent protective plate should have sufficient strength in order to the resist
external force.
former generates corrosive gas of attacking the polarizer at high temperature and the latter
causes circuit break by electro-chemical reaction.
HB pencil lead. And please do not rub with dust clothes with chemical treatment. Do not touch
the surface of polarizer for bare hand or greasy cloth. (Some cosmetics are detrimental to the
polarizer.)
materials like chamois soaks with petroleum benzene. Normal-hexane is recommended for
cleaning the adhesives used to attach front/ rear polarizers. Do not use acetone, toluene and
alcohol because they cause chemical damage to the polarizer.
causes deformations and color fading.
V=±200mV(Over and under shoot voltage)
lower temperature, response time (required time that brightness is stable after turned on)
becomes longer.
polarizer or electrical contacted parts. And after fading condensation, smear or spot will occur.
T140VN01 Ver.0.1
http://www.fineprint.com
24/24