t18xsd1eq Banner Engineering Corp., t18xsd1eq Datasheet - Page 7

• Manufacturer Part Number: t18xsd1eq
• Manufacturer: Banner Engineering Corp.

8
10
Attribute
Banner Engineering Corp. • Minneapolis, U.S.A.
Website: http://www.baneng.com • Tel: [phone]
0
1
2
3
4
6
7
8
9
I/O Type
Baud Rate
Device Type
Vendor Identification Number 50 decimal.
Device Address
Unsolicited Mode Enable
Software version Number
Diagnostic Error Counter
Bus Diagnostics Register
Cyclical Timer
Description
18,1,0,0,0,0 These six bytes indicate that this is a single point binary input with the input
variable at Attribute #18.
Always returns 0. This indicates that this device automatically determines the correct baud
rate for communication.
Indicates type of device in terms of the SDS protocol. This is presented as 4 X 8 bit words:
01.01.01.05 hex.
This variable indicates the network address of the device 0-125. It is the logical SDS address
minus 1. If the SDS address of this device is 1 this attribute will be 0. Default value is 125
decimal. This attribute is stored in non-volatile memory.
Setting this bit allows the device to send I/O event driven messages. These event messages
include: COS ON, COS OFF, WRITE ON, WRITE OFF. If this bit is cleared, then only the error
event (event 0) is generated. All other events will be disabled. This attribute is stored in non-
volatile memory.
ASCII character string “XXXXX-X.X”
The Diagnostic Error Counter indicates the number of error flags that are currently set in
attribute #9. The possible values of this counter are 0, 1, 2, 3 or 4.
This is a 2 byte read or write register. When an error occurs, the corresponding bit is set.
Setting to a non-zero value will enable unsolicited WRITE-ON or WRITE-OFF messages to be
transmitted with a real time interval equal to 10.24 ms multiplied by the set value. These
messages will reflect the current state of the input variable (attribute #18). This attribute is
stored in non-volatile memory.
bit 0 ROM Checksum Error
bit 7 EEPROM Failure
bit 1 not used = 0
bit 2 Off-Bus error
bit 3 reserved = 0
bit 4 reserved = 0
bit 5 not used = 0
bit 6 not used = 0
Attributes
Byte 1
Action
bit 0 not used = 0
bit 1 not used = 0
bit 2 not used = 0
bit 3 reserved = 0
bit 4 reserved = 0
bit 5 not used = 0
bit 6 Low Gain Alarm
bit 7 not used = 0
T18XSD Series
Byte 2
page
7