sam4s8c ATMEL Corporation, sam4s8c Datasheet - Page 52

• Manufacturer Part Number: sam4s8c
• Description: At91sam Arm-based Flash Mcu
• Manufacturer: ATMEL Corporation

11.8
11.9
11.10 Analog-to-Digital Converter (ADC12B)
52
High Speed Multimedia Card Interface (HSMCI)
USB Device Port (UDP)
• One programmable Fault Input providing an asynchronous protection of outputs
• Stepper motor control (2 Channels)
• 4-bit or 1-bit Interface
• Compatibility with MultiMedia Card Specification Version 4.3
• Compatibility with SD and SDHC Memory Card Specification Version 2.0
• Compatibility with SDIO Specification Version V1.1.
• Compatibility with CE-ATA Specification 1.1
• Cards clock rate up to Master Clock divided by 2
• Boot Operation Mode support
• High Speed mode support
• Embedded power management to slow down clock rate when not used
• MCI has one slot supporting
• Support for stream, block and multi-block data read and write
• USB V2.0 full-speed compliant,12 Mbits per second.
• Embedded USB V2.0 full-speed transceiver
• Embedded 2688-byte dual-port RAM for endpoints
• Eight endpoints
• Suspend/resume logic
• Integrated Pull-up on DDP
• Pull-down resistor on DDM and DDP when disabled
• up to 16 Channels, 12-bit ADC
• 10/12-bit resolution
• up to 1 MSample/s
• Programmable conversion sequence conversion on each channel
• Integrated temperature sensor
• Automatic calibration mode
– One MultiMediaCard bus (up to 30 cards) or
– One SD Memory Card
– One SDIO Card
– Endpoint 0: 64bytes
– Endpoint 1 and 2: 64 bytes ping-pong
– Endpoint 3: 64 bytes
– Endpoint 4 and 5: 512 bytes ping-pong
– Endpoint 6 and 7: 64 bytes ping-pong
– Ping-pong Mode (two memory banks) for Isochronous and bulk endpoints
11100AS–ATARM–27-Oct-11