at24c128b ATMEL Corporation, at24c128b Datasheet - Page 3

no-image

at24c128b

Manufacturer Part Number
at24c128b
Description
Two-wire Serial Eeprom 128k 16,384 X 8
Manufacturer
ATMEL Corporation
Datasheet

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
at24c128b-PU
Manufacturer:
ATMEL
Quantity:
5 000
Part Number:
at24c128b-PU
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
at24c128b-TH-B
Manufacturer:
Atmel
Quantity:
15
Part Number:
at24c128b-TH-B
Manufacturer:
ATMEL10
Quantity:
120
Part Number:
at24c128b-TH-B
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
at24c128b-TH-T
Manufacturer:
ATMEL
Quantity:
26 550
Part Number:
at24c128b-TH-T
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
at24c128bN-SH
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
at24c128bN-SH-B
Manufacturer:
ATMEL/爱特梅尔
Quantity:
20 000
Part Number:
at24c128bN-SH-T
Manufacturer:
ATMEL
Quantity:
8 000
Part Number:
at24c128bN-SH-T
Manufacturer:
ATMEL
Quantity:
1 000
Part Number:
at24c128bN-SH-T
Manufacturer:
ALTERA
0
4. Pin Description
5296A–SEEPR–1/08
SERIAL CLOCK (SCL): The SCL input is used to positive-edge clock data into each EEPROM
device and negative-edge clock data out of each device.
SERIAL DATA (SDA): The SDA pin is bidirectional for serial data transfer. This pin is open-
drain driven and may be wire-ORed with any number of other open-drain or open-collector
devices.
DEVICE/PAGE ADDRESSES (A2, A1, A0): The A2, A1, and A0 pins are device address inputs
that are hardwired (directly to GND or to Vcc) for compatibility with other AT24Cxx devices.
When the pins are hardwired, as many as eight 128K devices may be addressed on a single bus
system. (Device addressing is discussed in detail under “Device Addressing,”
is selected when a corresponding hardware and software match is true. If these pins are left
floating, the A2, A1, and A0 pins will be internally pulled down to GND. However, due to capaci-
tive coupling that may appear during customer applications, Atmel recommends always
connecting the address pins to a known state. When using a pull-up resistor, Atmel recommends
using 10kΩ or less.
WRITE PROTECT (WP): The write protect input, when connected to GND, allows normal write
operations. When WP is connected directly to Vcc, all write operations to the memory are inhib-
ited. If the pin is left floating, the WP pin will be internally pulled down to GND. However, due to
capacitive coupling that may appear during customer applications, Atmel recommends always
connecting the WP pins to a known state. When using a pull-up resistor, Atmel recommends
using 10kΩ or less.
page
8.) A device
3

Related parts for at24c128b