mb95fv100d-103 Fujitsu Microelectronics, Inc., mb95fv100d-103 Datasheet - Page 16

• Manufacturer Part Number: mb95fv100d-103
• Description: 8-bit Proprietary Microcontrollers
• Manufacturer: Fujitsu Microelectronics, Inc.

16
MB95100AM Series
I HANDLING DEVICES
• Preventing Latch-up
• Stable Supply Voltage
• Precautions for Use of External Clock
I PIN CONNECTION
• Treatment of Unused Input Pin
• Treatment of Power Supply Pins on A/D Converter
• Power Supply Pins
Care must be taken to ensure that maximum voltage ratings are not exceeded when they are used.
Latch-up may occur on CMOS ICs if voltage higher than V
other than medium- and high-withstand voltage pins or if higher than the rating voltage is applied between V
pin and V
When latch-up occurs, power supply current increases rapidly and might thermally damage elements.
Also, take care to prevent the analog power supply voltage (AV
the digital power supply voltage (V
Supply voltage should be stabilized.
A sudden change in power-supply voltage may cause a malfunction even within the guaranteed operating range
of the Vcc power-supply voltage.
For stabilization, in principle, keep the variation in Vcc ripple (p-p value) in a commercial frequency range
(50 Hz/60 Hz) not to exceed 10% of the standard Vcc value and suppress the voltage variation so that the
transient variation rate does not exceed 0.1 V/ms during a momentary change such as when the power supply
is switched.
Even when an external clock is used, oscillation stabilization wait time is required for power-on reset, wake-up
from sub clock mode or stop mode.
Leaving unused input pins unconnected can cause abnormal operation or latch-up, leaving to permanent dam-
age. Unused input pins should always be pulled up or down through resistance of at least 2 kΩ. Any unused
input/output pins may be set to output mode and left open, or set to input mode and treated the same as unused
input pins. If there is unused output pin, make it to open.
Connect to be AV
Noise riding on the AV
as a bypass capacitor between AV
In products with multiple V
to avoid abnormal operations including latch-up. However, you must connect the pins to external power supply
and a ground line to lower the electro-magnetic emission level, to prevent abnormal operation of strobe signals
caused by the rise in the ground level, and to conform to the total output current rating.
Moreover, connect the current supply source with the V
It is also advisable to connect a ceramic bypass capacitor of approximately 0.1 µF between V
this device.
SS
pin.
CC
= V
CC
CC
pin may cause accuracy degradation. So, connect approx. 0.1 µF ceramic capacitor
and AV
CC
or V
SS
SS
CC
CC
= AVR = V
pins, the pins of the same potential are internally connected in the device
) when the analog system power supply is turned on or off.
and AV
SS
SS
pins in the vicinity of this device.
even if the A/D converter is not in use.
CC
CC
and V
or lower than V
CC
, AVR) and analog input voltage from exceeding
SS
pins of this device at the low impedance.
SS
is applied to input and output pins
CC
and V
SS
near
CC