LTC1275 LINER [Linear Technology], LTC1275 Datasheet - Page 16

• Manufacturer Part Number: LTC1275
• Description: 12-Bit, 300ksps Sampling A/D Converters with Reference
• Manufacturer: LINER [Linear Technology]

LTC1273
LTC1275/LTC1276
A
on all three inputs to initiate a conversion. Once initiated it
cannot be restarted until the conversion is complete.
Converter status is indicated by the BUSY output, and this
is low while conversion is in progress.
There are two modes of operation as outlined by the timing
diagrams of Figures 13 to 16. Slow Memory Mode is
designed for microprocessors which can be driven into a
WAIT state. A READ operation brings CS and RD low which
initiates a conversion and data is read when conversion is
complete. The second is the ROM Mode which does not
require microprocessor WAIT states. A READ operation
brings CS and RD low which initiates a conversion and
reads the previous conversion result.
Data Format
The output format can be either a complete parallel load for
16-bit microprocessors or a two byte load for 8-bit micro-
processors. Data is always right justified (i.e., LSB is the
most right-hand bit in a 16-bit word). For a two byte read,
only data outputs D7...D0/8 are used. Byte selection is
governed by the HBEN input which controls an internal
digital multiplexer. This multiplexes the 12-bits of conver-
sion data onto the lower D7...D0/8 outputs (4MSBs or
16
Table 2. Slow Memory Mode, Parallel Read Data Bus Status
Data Outputs
Read
PPLICATI
DB11
D11
O
U
TRACK
S
HOLD
BUSY
DATA
DB10
D10
RD
RD
CS
I FOR ATIO
U
t
1
Figure 13. Slow Memory Mode, Parallel Read Timing Diagram
DB9
t
t
t
D9
3
12
2
W
DB8
OLD DATA
DB11-DB0
D8
t
CONV
U
DB7
D7
t
6
NEW DATA
DB11-DB0
DB6
D6
8MSBs) where it can be read in two read cycles. The
4MSBs always appear on D11...D8 whenever the three-
state output drivers are turned on.
Slow Memory Mode, Parallel Read (HBEN = LOW)
Figure 13 and Table 2 show the timing diagram and data
bus status for Slow Memory Mode, Parallel Read. CS and
RD going low trigger a conversion and the ADC acknowl-
edges by taking BUSY low. Data from the previous conver-
sion appears on the three-state data outputs. BUSY re-
turns high at the end of conversion when the output
latches have been updated and the conversion result is
placed on data outputs D11...D0/8.
Slow Memory Mode, Two Byte Read
For a two byte read, only 8 data outputs D7...D0/8 are used.
Conversion start procedure and data output status for the
first read operation are identical to Slow Memory Mode,
Parallel Read. See Figure 14 timing diagram and Table 3
data bus status. At the end of the conversion, the low data
byte (D7...D0/8) is read from the ADC. A second READ
operation, with the HBEN high, places the high byte on data
outputs D3/11...D0/8 and disables conversion start. Note
t
t
7
5
t
DB5
11
D5
t
10
DB4
D4
LTC1273/75/76 • F13
t
1
D3/11
DB3
D2/10
DB2
D1/9
DB1
D0/8
DB0