AT89C51IC2-RLTIM ATMEL [ATMEL Corporation], AT89C51IC2-RLTIM Datasheet - Page 107

no-image

AT89C51IC2-RLTIM

Manufacturer Part Number
AT89C51IC2-RLTIM
Description
8-bit Flash Microcontroller with 2-wire Interface
Manufacturer
ATMEL [ATMEL Corporation]
Datasheet
Flash EEPROM
Memory
Features
Flash Programming and
Erasure
4301C–8051–06/06
The Flash memory increases EPROM and ROM functionality with in-circuit electrical
erasure and programming. It contains 32K Bytes of program memory organized in 128
or 256 pages of 128 Bytes. This memory is both parallel and serial In-system Program-
mable (ISP). ISP allows devices to alter their own program memory in the actual end
product under software control. A default serial loader (bootloader) program allows ISP
of the Flash.
The programming does not require external dedicated programming voltage. The nec-
essary high programming voltage is generated on-chip using the standard V
the microcontroller.
The 32K Bytes Flash is programmed by Bytes or by pages of 128 Bytes. It is not neces-
sary to erase a Byte or a page before programming. The programming of a Byte or a
page includes a self erase before programming.
There are three methods of programming the Flash memory:
Flash EEPROM internal program memory.
Boot vector allows user provided Flash loader code to reside anywhere in the Flash
memory space. This configuration provides flexibility to the user.
Default loader in Boot ROM allows programming via the serial port without the need
of a user-provided loader.
Up to 64K Byte external program memory if the internal program memory is
disabled (EA = 0).
Programming and erase voltage with standard 5V or 3V V
Read/Programming/Erase:
Typical programming time (32K Bytes) in 10 s
Parallel programming with 87C51 compatible hardware interface to programmer
Programmable security for the code in the Flash
10K write cycles
10 years data retention
First, the on-chip ISP bootloader may be invoked which will use low level routines to
program the pages. The interface used for serial downloading of Flash is the UART.
Second, the Flash may be programmed or erased in the end-user application by
calling low-level routines through a common entry point in the Boot ROM.
Third, the Flash may be programmed using the parallel method by using a
conventional EPROM programmer. The parallel programming method used by
these devices is similar to that used by EPROM 87C51 but it is not identical and the
commercially available programmers need to have support for the AT89C51IC2.
The bootloader and the Application Programming Interface (API) routines are
located in the BOOT ROM.
Byte-wise read without wait state
Byte or page erase and programming (10 ms)
CC
AT89C51IC2
supply.
CC
pins of
107

Related parts for AT89C51IC2-RLTIM