MAX2366 MAXIM [Maxim Integrated Products], MAX2366 Datasheet - Page 8

• Manufacturer Part Number: MAX2366
• Description: Complete Dual-Band Quadrature Transmitters
• Manufacturer: MAXIM [Maxim Integrated Products]

Complete Dual-Band
Quadrature Transmitters
8
MAX2366
MAX2360
13, 14, 15
10, 11
_______________________________________________________________________________________
8, 9
12
—
1
2
3
4
5
6
7
1, 8, 9, 18,
19, 30, 31,
MAX2367
34, 35, 44
13, 14, 15
10, 11
PIN
12
—
—
2
3
4
5
6
7
MAX2368
13, 14, 15
2, 10, 11,
16, 17,
43, 47
32–35
8, 9
—
—
12
1
3
4
5
6
7
TXGATE
CLK, DI,
IFINH+,
IFINL+,
NAME
IFINH-
LOCK
IFINL-
RFH0
R
IDLE
N.C.
RFL
V
V
CS
BIAS
CC
CC
Transmitter RF Output for Cellular Band (800MHz to 1000MHz)—for both FM
and digital modes. This open-collector output requires a pullup inductor to
the supply voltage, which may be part of the output matching network and
may be connected directly to the battery.
No Connection. Make no connection to these pins.
Transmitter RF Output for PCS Band (1700MHz to 2000MHz). This open-
collector output requires a pullup inductor to the supply voltage. The pullup
inductor may be part of the output matching network and may be connected
directly to the battery.
Open-Collector Output Indicating Lock Status of the IF and/or the RF PLLs.
Requires a pullup resistor. Control using configuration register bit LD_MODE0,
LD_MODE1.
Power Supply
Digital Input. A logic low on IDLE shuts down everything except the RF PLL
and associated registers. A small R-C lowpass filter may be used to prevent
digital noise.
Supply Pin for the Upconverter Stage. V
ground as close to the pin as possible. The ground vias for the bypass
capacitor should not be shared by any other branch.
Digital Input. A logic low on TXGATE shuts down everything except the RF
PLL, IF PLL, IF VCO, and serial bus and registers. This mode is used for
gated transmission.
Differential Inputs to the RF Upconverter. These pins are internally biased to
+1.5V. The input impedance for these ports is nominally 400Ω differential.
The IF filter should be AC-coupled to these ports. Keep the differential lines
as short as possible to minimize stray pickup and shunt capacitance.
Differential Inputs to the RF Upconverter. These pins are internally biased to
+1.5V. The input impedance for these ports is nominally 400Ω differential.
The IF filter should be AC-coupled to these ports. Keep the differential lines
as short as possible to minimize stray pickup and shunt capacitance.
Bias Resistor Pin. RBIAS is internally biased to a bandgap voltage of +1.18V. An
external resistor or current source must be connected to this pin to set the bias
current for the upconverters and PA driver stages. The nominal resistor value is
16kΩ. This value can be altered to optimize the linearity of the driver stage.
Input Pins from the 3-Wire Serial Bus (SPI/QSPI/MICROWIRE compatible).
An R-C filter on each of these pins may be used to reduce noise.
FUNCTION
CC
must be bypassed to system
Pin Description