M306V5EESP Mitsubishi, M306V5EESP Datasheet - Page 67

• Manufacturer Part Number: M306V5EESP
• Description: SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER and ON-SCREEN DISPLAY CONTROLLER
• Manufacturer: Mitsubishi

Rev. 1.0
Figure 2.9.9 An example of DMA transfer effected by external factors
(3) The priorities of channels and DMA transfer timing
The timing for the DMA request bit to turn to 1 when an external factor is selected synchronizes with
the signal’s edge applicable to the function specified by the DMA request factor selection bit (synchro-
nizes with the trailing edge of the input signal to each INTi pin, for example).
With an external factor selected, the DMA request bit is timed to turn to 0 immediately before data
transfer starts similarly to the state in which an internal factor is selected.
If a DMA transfer request signal falls on a single sampling cycle (a sampling cycle means one period
from the leading edge to the trailing edge of BCLK), the DMA request bits of applicable channels
concurrently turn to 1. If the channels are active at that moment, DMA0 is given a high priority to start
data transfer. When DMA0 finishes data transfer, it gives the bus right to the CPU. When the CPU
finishes single bus access, then DMA1 starts data transfer and gives the bus right to the CPU. Figure
2.9.9 illustrates these operations.
An example in which DMA transfer is carried out in minimum cycles at the time when DMA transfer
request signals due to external factors concurrently occur.
BCLK
DMA0
DMA1
CPU
INT0
INT1
DMA1
request bit
DMA0
request bit
An example in which DMA transmission is carried out in minimum
cycles at the time when DMA transmission request signals due to
external factors concurrently occur.
SINGLE-CHIP 16-BIT CMOS MICROCOMPUTER with CLOSED CAPTION DECODER
_______
and ON-SCREEN DISPLAY CONTROLLER
MITSUBISHI MICROCOMPUTERS
M306V5ME-XXXSP
M306V5EESP
Obtainm
ent of the
bus right
67