CX28332 Conexant Systems, CX28332 Datasheet - Page 48

• Manufacturer Part Number: CX28332
• Description: (CX28331 - CX28333) Single/Dual/Triple E3/DS3/STS-1 Line Interface Unit
• Manufacturer: Conexant Systems

2.0 Functional Description
2.5 Additional CX2833i Functions
2.5.1 Bias Generator
2.5.2 Power-On Reset (POR)
2.5.3 Loopback Multiplexers (MUXes)
2-16
2.5 Additional CX2833i Functions
To achieve good isolation between the channels, each channel utilizes an
independent power and ground to both transmit and receive. Additionally, each
channel has its own band gap voltage reference. Because only one external
resistor for current generation exists, only one band gap voltage can be used. The
band gap from Ch1 has been chosen for this task.
a tolerance of ±1%. This helps to keep tighter control on power dissipation and
circuit performance.
NOTE:
A POR function is provided in the CX2833i device to ensure all of the resettable
digital logic and analog control lines are starting from a known state. This circuit
uses a fixed RC timer (~1 s); additionally, 128 clocks from REFCLK are counted
(after the RC timer has timed-out) before reset is deasserted, which begins timing
after a minimum supply voltage is reached (see
Two loopback MUXes per channel in the CX2833i allow for local loopback
(terminal or framer side), remote loopback (cable side), or both (the AIS signal
follows the same path as the transmit data during loopback). The RLOS signal
monitors the RX cable inputs irrespective of any loopback.
(retimed after clock recovery but not decoded) loops back into the pulse shaper in
place of the transmit data. Additionally, this data sent out the RPOS, RNEG, and
RCLK pins.
immediately from the encoder output to the decoder input in place of the received
data. Additionally, this data is sent out the TLINEP and TLINEM/N pins.
The 12.1 k external resistor from pin RBIAS to ground, is specified to have
In remote loopback, set by asserting pin RLOOP high, the receive data
In local loopback, set by asserting pin LLOOP, the transmit data loops back
Capacitance should be kept to a minimum on the RBIAS pin.
Conexant
Single/Dual/Triple E3/DS3/STS-1 Line Interface Unit
Table
CX28331/CX28332/CX28333
2-4).
100985A