MAX691ACSE-T Maxim Integrated, MAX691ACSE-T Datasheet - Page 15

• Manufacturer Part Number: MAX691ACSE-T
• Description: Supervisory Circuits
• Manufacturer: Maxim Integrated
• Series: MAX691A, MAX693A, MAX800, MAX800L, MAX800Mr

Specifications of MAX691ACSE-T

• Number Of Voltages Monitored: 1
• Monitored Voltage: 0 V to 5.5 V
• Undervoltage Threshold: 4.5 V
• Overvoltage Threshold: 4.75 V
• Output Type: Active High, Active Low, Open Drain
• Manual Reset: Not Resettable
• Watchdog: Watchdog
• Battery Backup Switching: Backup
• Power-up Reset Delay (typ): 280 ms
• Supply Voltage - Max: 5.5 V
• Maximum Operating Temperature: + 70 C
• Mounting Style: SMD/SMT
• Package / Case: SOIC-16 Narrow
• Chip Enable Signals: Yes
• Maximum Power Dissipation: 696 mW
• Minimum Operating Temperature: 0 C
• Power Fail Detection: Yes
• Supply Current (typ): 100 uA
• Supply Voltage - Min: 0 V

The V
the battery switchover comparator and should not
exceed 0.03V/µs. A standard rule of thumb for filter
capacitance on most regulators is on the order of 100µF
per amp of current. When the power supply is shut off or
the main battery is disconnected, the associated initial
V
The V
nentially, which more than satisfies the maximum fall-time
requirement.
A way to help the watchdog timer keep a closer watch
on software execution involves setting and resetting the
watchdog input at different points in the program,
rather than “pulsing” the watchdog input high-low-high
or low-high-low. This technique avoids a “stuck” loop
where the watchdog timer continues to be reset within
the loop, keeping the watchdog from timing out. Figure
14 shows an example flow diagram where the I/O dri-
ving the watchdog input is set high at the beginning of
the program, set low at the beginning of every subrou-
tine or loop, then set high again when the program
returns to the beginning. If the program should “hang”
in any subroutine, the I/O is continually set low and the
watchdog timer is allowed to time out, causing a reset
or interrupt to be issued.
CC
fall rate is just the inverse or 1A/100µF = 0.01V/µs.
CC
CC
fall rate decreases with time as V
fall time is limited by the propagation delay of
Watchdog Software Considerations
______________________________________________________________________________________
Maximum V
Microprocessor Supervisory Circuits
CC
CC
Fall Time
falls expo-
Figure 14. Watchdog Flow Diagram
OR PROGRAM LOOP
SUBROUTINE
SET WDI
RETURN
START
LOW
HIGH
END
WDI
SET
15