MD4811-D512-V3Q18-P/Y SanDisk, MD4811-D512-V3Q18-P/Y Datasheet - Page 15

• Manufacturer Part Number: MD4811-D512-V3Q18-P/Y
• Description: IC MDOC G3 512MB 48-TSOP
• Manufacturer: SanDisk

Specifications of MD4811-D512-V3Q18-P/Y

• Format - Memory: FLASH
• Memory Type: FLASH - Nand
• Memory Size: 512M (64M x 8)
• Speed: 55ns
• Interface: Parallel
• Voltage - Supply: 2.5 V ~ 3.6 V
• Operating Temperature: 0°C ~ 70°C
• Package / Case: 48-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 585-1135

12
The following abbreviations are used: IN - Standard (non-Schmidt) input, ST - Schmidt Trigger input, OD - Open drain output, R8 - Nominal
22K pull-up resistor, enabled only for 8-bit interface mode (IF_CFG input is 0)
DMARQ#
IRQ#
DPD
VCC
VCCQ
VSS
RSRVD
Signal
13, 25, 36, 48
Pin No.
47
19
12
37
20
21
Input
Type
OD
OD
ST
-
-
-
-
Preliminary Data Sheet, Rev. 1.1
Device core power supply. Requires a 10 nF and
I/O power supply. Sets the logic 1 voltage level
Reserved. If compatibility with previous
DMA Request, active low. A 10 KΩ pull-up resistor
is required if this pin drives an input. A 10 KΩ pull-
up resistor is recommended even if this pin is not
used.
Interrupt Request, active low. A 10 KΩ pull-up
resistor is required if this pin drives an input. A 10
KΩ pull-up resistor is recommended even if this pin
is not used.
Deep Power-Down. Used to enter and exit Deep
Power-Down mode. This pin is assigned A0
instead of DPD when working in 8-bit mode.
0.1 μF capacitor.
range of I/O pins. VCCQ may be either 2.5V to
3.6V or 1.65V to 2.0V. Requires a 10 nF and
0.1 μF capacitor.
Ground. All VSS pins must be connected.
DiskOnChip versions is necessary:
In 16-bit mode (IF_CFG = 1) this pin must be
connected to GND for compatibility with G2
devices.
In 8-bit mode (IF_CFG = 0) may be left floating.
Refer to application note AP-DOC-067 for design
guidelines when migrating from previous
DiskOnChip versions (G2).
Power
Other
Description
Mobile DiskOnChip G3
91-SR-011-05-8L
Supply
Supply
Supply
Signal
Output
Output
Type
Input