LM5100AMR/NOPB National Semiconductor, LM5100AMR/NOPB Datasheet - Page 7

• Manufacturer Part Number: LM5100AMR/NOPB
• Description: IC DVR HALF-BRIDGE HV 8-PSOP
• Manufacturer: National Semiconductor

Specifications of LM5100AMR/NOPB

• Configuration: High and Low Side, Synchronous
• Input Type: Non-Inverting
• Delay Time: 20ns
• Current - Peak: 3A
• Number Of Configurations: 1
• Number Of Outputs: 2
• High Side Voltage - Max (bootstrap): 118V
• Voltage - Supply: 9 V ~ 14 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-PSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: *LM5100AMR/NOPB; LM5100AMR; LM5100AMRTR; LM5100AMRTR

t
t
PW
BS
Symbol
Note 1: Absolute Maximum Ratings indicate limits beyond which damage to the component may occur. Operating Ratings are conditions under which operation
of the device is guaranteed. Operating Ratings do not imply guaranteed performance limits. For guaranteed performance limits and associated test conditions,
see the Electrical Characteristics tables.
Note 2: The human body model is a 100 pF capacitor discharged through a 1.5kΩ resistor into each pin. 2 kV for all pins except Pin 2, Pin 3 and Pin 4 which are
rated at 1000V for HBM and 100V for MM.
Note 3: 4 layer board with Cu finished thickness 1.5/1/1/1.5 oz. Maximum die size used. 5x body length of Cu trace on PCB top. 50 x 50mm ground and power
planes embedded in PCB. See Application Note AN-1187.
Note 4: Min and Max limits are 100% production tested at 25°C. Limits over the operating temperature range are guaranteed through correlation using Statistical
Quality Control (SQC) methods. Limits are used to calculate National’s Average Outgoing Quality Level (AOQL).
Note 5: The θ
Note 6: In the application the HS node is clamped by the body diode of the external lower N-MOSFET, therefore the HS node will generally not exceed -1V.
However, in some applications, board resistance and inductance may result in the HS node exceeding this stated voltage transiently. If negative transients occur,
the HS voltage must never be more negative than VDD-15V. For example if VDD = 10V, the negative transients at HS must not exceed -5V.
Typical Performance Characteristics
Minimum Input Pulse Width that Changes
the Output
Bootstrap Diode Reverse Recovery Time I
JA
is not a given constant for the package and depends on the printed circuit board design and the operating environment.
Sink Current vs Output Voltage
Peak Sourcing Current vs VDD
Parameter
20203129
20203127
I
F
R
= 100 mA,
= 100 mA
Conditions
7
Source Current vs Output Voltage
Peak Sinking Current vs VDD
Min
Typ
50
37
Max
20203130
20203128
www.national.com
Units
ns
ns