PC410L0NIP0F Sharp Microelectronics, PC410L0NIP0F Datasheet - Page 9

• Manufacturer Part Number: PC410L0NIP0F
• Description: PHOTOCOUPLER OPIC 5-SOP
• Manufacturer: Sharp Microelectronics
• Series: OPIC™r

Specifications of PC410L0NIP0F

• Voltage - Isolation: 3750Vrms
• Number Of Channels: 1, Unidirectional
• Current - Output / Channel: 50mA
• Data Rate: 10Mbps
• Propagation Delay High - Low @ If: 48ns @ 7.5mA
• Current - Dc Forward (if): 20mA
• Input Type: DC
• Output Type: Open Collector
• Mounting Type: Surface Mount
• Package / Case: 6-SOIC (0.173", 4.40mm Width) 5 Leads
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 425-2141-2

■ Design Considerations
● Degradation
● Recommended Foot Print (reference)
● Recommended operating conditions
● Notes about static electricity
● Design guide
✩ For additional design assistance, please review our corresponding Optoelectronic Application Notes.
Transistor of detector side in bipolar configuration may be damaged by static electricity due to its minute de-
sign.
When handling these devices, general countermeasure against static electricity should be taken to avoid
breakdown of devices or degradation of characteristics.
In order to stabilize power supply line, we should certainly recommend to connect a by-pass capacitor of
0.01µF or more between V
In case that some sudden big noise caused by voltage variation is provided between primary and secondary
terminals of photocoupler some current caused by it is floating capacitance may be generated and result in
false operation since current may go through LED or current may change.
If the photocoupler may be used under the circumstances where noise will be generated we recommend to
use the bypass capacitors at the both ends of LED.
The detector which is used in this device, has parasitic diode between each pins and GND.
There are cases that miss operation or destruction possibly may be occurred if electric potential of any pin
becomes below GND level even for instant.
Therefore it shall be recommended to design the circuit that electric potential of any pin does not become
below GND level.
This product is not designed against irradiation and incorporates non-coherent LED.
In general, the emission of the LED used in photocouplers will degrade over time.
In the case of long term operation, please take the general LED degradation (50% degradation over 5 years)
into the design consideration.
Please decide the input current which become 2 times of MAX. I
Low level input current
High level input current
Supply voltage
Fan out (TTL load)
Operating temperature
Parameter
Symbol
V
T
I
I
CC
N
FH
FL
opr
CC
and GND near the device.
MIN.
−40
4.5
0
8
−
1.5
TYP.
−
−
−
−
−
9
6.3
MAX.
250
+70
5.5
15
5
FHL
Unit
mA
µA
˚C
V
.
−
PC410L0NIP0F Series
Sheet No.: D2-A04802EN
(Unit : mm)