LQ104S1DG21 Sharp Microelectronics, LQ104S1DG21 Datasheet - Page 16

• Manufacturer Part Number: LQ104S1DG21
• Description: LCD TFT 10.4" 800X600 SVGA
• Manufacturer: Sharp Microelectronics

Specifications of LQ104S1DG21

• Display Type: LCD - Color
• Display Mode: *
• Viewing Area: 211.20mm L x 158.40mm W
• Dot Pixels: 800 x 600 (SVGA)
• Pixel Density: 800 x 600
• Module Size (w X H X T): 246.5 mm x 179.4 mm x 15.5 mm
• Backlighting: White
• Diagonal: 10.4 in
• Viewing Area (w X H): 211.2 mm x 158.4 mm
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Interface: -
• Backlight: -
• Dot Size: -
• Dot Pitch: -
• Lead Free Status / Rohs Status: Details
• Other names: 425-2472

10. Display Quality
11 Handling Precautions
12.Packing form
a) Be sure to turn off the power supply when inserting or disconnecting the cable.
b) Be sure to design the cabinet so that the module can be installed without any extra stress such as warp or twist.
c) Since the front polarizer is easily damaged, pay attention not to scratch it.
d) Wipe off water drop immediately. Long contact with water may cause discoloration or spots.
e) When the panel surface is soiled, wipe it with absorbent cotton or other soft cloth.
f) Since the panel is made of glass, it may break or crack if dropped or bumped on hard surface. Handle with care.
g) Since CMOS LSI is used in this module, take care of static electricity and injure the human earth when handling.
i) The polarizer surface on the panel is treated with Anti-Glare for low reflection. In case of attaching
j) Do not expose the LCD panel to direct sunlight. Lightproof shade etc. should be attached when LCD panel is used
k) Connect GND to 4 place of mounting holes to stabilize against EMI and external noise.
l) There are high voltage portions on the backlight and very dangerous. Careless touch may lead to
m) When handling LCD modules and assembling them into cabinets, please be noted that long-term
n)Cold cathode fluorescent lamp in LCD panel contains a small amount of mercury, please follow local
o) Be sure not to apply tensile stress to the lamp lead cable.
h) Protection film is attached to the module surface to prevent it from being scratched .
ordinances or regulations for disposal.
The display quality of the color TFT-LCD module shall be in compliance with the Incoming Inspection Standard.
under such environment.
Observe all other precautionary requirements in handling electric components.
Peel the film off slowly , just before the use, with strict attention to electrostatic charges.
Blow off 'dust' on the polarizer by using an ionized nitrogen.
protective board over the LCD. Be careful about the optical interface fringe etc.
Which degrades display quality.
electrical shock. When exchange lamps or service. Turn off the power without tail.
storage in the environment of oxidization or deoxidization gas and the use of such materials as reagent,
solvent, adhesive, resin, etc. which generate these gasses, may cause corrosion and discoloration of the
LCD modules.
Product country
Piling number of cartons
Packing quantity in one carton
Carton size [mm]
Total mass of one carton filled
with full modules
JAPAN
494(W)×326(D)×433(H)
5 Max
15.6kg
20
TAIWAN