M0216MD-162MDBR2-J Newhaven Display, M0216MD-162MDBR2-J Datasheet - Page 5

• Manufacturer Part Number: M0216MD-162MDBR2-J
• Description: MODULE VF CHAR 2X16 9.22MM
• Manufacturer: Newhaven Display

Specifications of M0216MD-162MDBR2-J

• Outline L X W X H: 122.00mm x 44.00mm x 20.00mm
• Display Format: 16 x 2
• Display Type: Character
• Format: 5 x 7 Dots
• Voltage - Supply: 5V
• Character Size: 9.20mm H x 3.80mm W
• Operating Temperature: -20°C ~ 70°C
• Product: Character Display Modules
• Character Count X Line: 16 x 2
• Module Size (w X H X T): 122 mm x 44 mm x 20 mm
• Voltage Rating: 5 V
• Operating Temperature Range: - 20 C to + 70 C
• Dot Format: 5 x 7
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Interface: -
• Viewing Area: -
• Number Of Dots: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

4.8.6 SYNCHRONOUS SERIAL INTERFACE MODE
In the synchronous serial interface mode, instructions and data are sent between the host and the module using 8‐bit
bytes. Two bytes are required per read/write cycle and are transmitted MSB first. The start byte contains 5 high bits, the
Read/Write (R/W) control bit, the Register Select (RS) control bit, and a low bit. The following byte contains the
instruction/data bits. The R/W bit determines whether the cycle is a read (high) or a write(low) cycle. The RS bit is used
to identify the second byte as an instruction (low) or data(high).This mode uses the Strobe (STB) control signal, Serial
Clock (SCK) input, and Serial I/O(SI/SO) line to transfer information. In a write cycle, bits are clocked into the module on
the rising edge of SCK. In a read cycle, bits in the start byte are clocked into the module on the rising edge of SCK. After
the minimum wait time, each bit in the instruction/data byte can be read from the module after each falling edge of
SCK. Each read/write cycle begin son the falling edge of STB and ends on the rising edge. To be a valid read/write cycle,
the STB must go high at the end of the cycle.
[5]