MA180021 Microchip Technology, MA180021 Datasheet - Page 10

• Manufacturer Part Number: MA180021
• Description: MODULE PLUG-IN 18F87J50 FS USB
• Manufacturer: Microchip Technology
• Series: PIC®r

Specifications of MA180021

• Accessory Type: Plug-In Module (PIM) - PIC18F87J50
• Silicon Manufacturer: Microchip
• Core Architecture: PIC
• Core Sub-architecture: PIC18
• Features: Full Speed USB Demonstration, Operated Either Stand Alone Or As Plug-In Module
• Silicon Core Number: PIC18F
• Silicon Family Name: PIC18FxxJxx
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With/related Products: HPC Explorer Board (DM183022) or PIC18 Explorer Board (DM183032)
• For Use With: DM183032 - BOARD EXPLORER PICDEM PIC18DM183022 - BOARD DEMO PIC18FXX22 64/80TQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

1.4
1.5
DS51678A-page 6
OVERVIEW OF THE PIC18F87J50 FAMILY USB CAPABILITIES
USING THE PREPROGRAMMED FIRMWARE
The PIC18F87J50 microcontroller is the “superset” device in the PIC18F87J50 micro-
controller family. The PIC18F87J50 has the highest memory and pin count in the family,
but otherwise shares an identical feature set (except features which require pins not
present on 64-pin devices) compared to the other devices. All of the devices in the fam-
ily are code-compatible with each other and share the same USB capabilities:
• USB 2.0 compliance
• Full-speed (12 Mbit/s) and low-speed (1.5 Mbit/s) operation
• Support of control, interrupt, bulk and isochronous transfers
• Support of up to 32 endpoints
• 3.9 Kbytes of dual access RAM for USB or general purpose use
• On-chip features for a single chip USB implementation, including:
The PIC18F87J50 FS USB Plug-In Module comes preprogrammed with HID class
firmware. Upon plugging in the USB cable to a Windows
PC, the device should automatically enumerate as a HID class mouse. The mouse
cursor should promptly begin moving around in a continuous circular pattern, and the
red LEDs on the PIM should begin blinking in an alternate manner. To stop the mouse
cursor from moving, simply press the “S4” push button located in the lower right corner
of the PIM. If the LEDs fail to illuminate, the device fails to enumerate or the mouse
does not move in a circle, verify that jumpers, JP4 and JP5, are installed. See
Figure 3-1 for the locations of these components.
- USB Serial Interface Engine (SIE)
- USB transceiver
- USB pull-up resistors
- D+ and D- driver output impedance matching resistors
®
operating system based host
© 2007 Microchip Technology Inc.