HS2238ECN61H Renesas Electronics America, HS2238ECN61H Datasheet - Page 23

• Manufacturer Part Number: HS2238ECN61H
• Description: DEV EMULATOR PCB ADAPTOR TPF-100
• Manufacturer: Renesas Electronics America

Specifications of HS2238ECN61H

• Accessory Type: User Interface Cable
• For Use With/related Products: H8S/2238
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Check the location of pin 1 before inserting the MCU into the IC socket on the user system, as
shown in figure 9. After inserting the MCU, fasten the socket cover with the provided four screws
(M2
the IC socket from being damaged by overtightening the screws or twisting the components.
12
x
1. Check the location of pin 1 before inserting.
2. Use the screwdriver provided for tightening screws.
3. The tightening torque must be 0.054 N•m or less.
4. If the MCU does not operate correctly, cracks might have
6 mm). Take special care, such as manually securing the IC socket soldered area, to prevent
Section 3 Installing the MCU to the User System
If the applied torque cannot be accurately measured,
stop tightening when the force required to turn the screw
becomes significantly greater than that needed when first
tightening. If a screw is tightened too much, the screw
head may break or an IC socket contact error may be
caused by a crack in the IC socket solder.
occurred in the solder. Check conduction with a tester
and re-solder the IC socket if necessary.
CA
UTION